Use & Care Manuals PDF

7
Before You Call for Service
Problem Solution Guide
PROBLEM MAY BE CAUSED BY WHAT TO DO
Nothing works. Power plug disconnected. Connect plug to a dedicated, grounded, three-
prong electrical outlet.
Timer is not set. Select time duration according to the
Operating Instructions section.
Warming drawer is not connected
to power.
Plug the warming drawer into a 120 Vac,
15 Amp., dedicated electrical outlet.
Tripped circuit breaker or blown
fuse.
Check the circuit breaker panel or fuse box
tripped breaker or blown fuse.
Ambient temperature below 32°F
(0°C).
Temperature around warming drawer must be
above freezing.
Drawer does not slide smoothly
or drags.
Drawer is incorrectly mounted into
slide mechanism.
Remount drawer into slide, per instructions
above
Drawer is over-loaded or the load
is unbalanced.
Reduce the weight to less than 50 pounds.
Redistribute drawer contents
Excessive condensation. Warming drawer not preheated. Preheat the warming drawer before each use
Incorrect humidity control setting. Set humidity control to CRISP to allow mois-
ture to vent
One or more of the indicator
lights on the control panel blink
on and off (one second on, one
second off).
The control panel computer has
detected an error:
#1 - Temperature error
#2 - Sensor error
#3 - Key pad error
#4 - Control error
Try resetting the computer. Disconnect the
power cord, wait 20 seconds, then reconnect
it. Check the control panel. If the indicator
light still ashes, call for service. See page 8
Care and Cleaning
Drawer Installation
Push in on tab
Drawer Removal
Pull up on
drawer front
Push drawer front
down until tab locks
in place
Slide mounting bracket
under clip on slide
Clip on slide
Slide