Planning Guide

PLANNING
GUIDE
All specications subject to change without notice. www.dacor.com Ph. 800.793.0093
24”, 27”, 30”, 36” Wide
Heritage Warming Drawers
Doc #: PGH-HWD.01 Revised 14 Sept 2018 Page 1 of 3
All tolerances: ±¹/₁₆” (±1.6 mm) unless otherwise stated.
DWD, EWD, ERWD, HWD/-F, IWD, OWD
WARNING
• Observe all local ordinances during planning and installation. Contact
your local building department for details.
• The drawer must be installed according to its installation instructions.
Handle Dimensions (side)
Chassis Dimensions
Overall Dimensions (top view)
Drawer open
Chassis
5/64"
(2 mm)
23 13/16”
(60.5 cm)
23 3/8”
(59.4 cm)
B
C
10"
(25.4 cm)
9"
(22.9 cm)
1/2" (1.3 cm)
1/2" (1.3 cm)
Chassis without
drawer inserted
Mounting
hole 9 places
40” (101.6 cm)
3-prong 120 Vac
power cord
Electrical Circuit
Required
Total Connected
Load
Min. Ambient
Operating Temp.
120 Vac, 60 Hz, 15 Amp.
grounded, dedicated circuit
4.0 Amp. @
120 Vac, 60 Hz.
32°F (0°C)
Drawer face heights are 10 ” (25.7 cm) x Width dimension (A); see
Warming Drawer Overall Dimensions table (below) for “A”
dimensions for all drawer models
Warming Drawer Overall Dimensions* (see left)
Model (A) Drawer Face Width (B) Chassis Face Width (C) Chassis Width
EWD24
HWD24PS
24” (61.0 cm) 23 ” (60.0 cm) 22 ” (56.5 cm)
ERWD27
EWD27
HWD27PS
27” (68.6 cm) 26 ” (67.6 cm) 25 ” (64.1 cm)
DWD30
ERWD30
EWD30
HWD30PS
HWDF30S
30” (76.2 cm) 29 ” (75.2 cm) 28 ” (71.8 cm)
*See Pg. 2 for IWD & OWD series chassis dimensions