Renaissance Wall Oven Service Guide Models: EORS127, EORS130, EORS227, EORS230, EORD227, EORD230, MORS127, MORS130, MORS227, MORS230, MORD227, MORD230 The Life of the Kitchen. ® Part No. 106075 Rev.
® Specifications subject to change without notice.
Table of Contents Table of Contents . Section 1 - Important Safety Instructions .................................. 1 Section 2 - General Information .................................................. 3 Contacting Dacor for Assistance ...................................... 3 Model and Serial Number................................................ 3 Finding the Appliance Data Plate.............................. 3 Reading the Serial Number ...................................... 3 Model Number Identification.
Dacor Renaissance Wall Oven Service Guide This page intentionally left blank.
Section 1 - Important Safety Instructions Section 1 - Important Safety Instructions WARNING: f Operate this appliance only as specified in this manual or the use and care manual. f Only a qualified installer should install this appliance. f Other than performing procedures specified in the Wall Oven Use and Care Manual, only a qualified service technician should service this appliance. To obtain the name of your closest Dacor service representative, call (800) 793-0093.
Dacor Renaissance Wall Oven Service Guide WARNING: f Do not line the oven with aluminum foil or other materials. These items can melt or burn up during selfcleaning and cause permanent damage to the oven. f Do not use a steam cleaner to clean the oven. Steam could penetrate electrical components and cause a short circuit. f Do not leave metal objects, such as aluminum foil, the meat probe, or cookie sheets, on the floor of the oven.
Section 2 - General Information Section 2 - General Information Contacting Dacor for Assistance For assistance with installing or servicing Dacor appliances: Phone: 1-800-353-2267 1440 Bridge Gate Drive Diamond Bar, CA 91765 Model and Serial Number Finding the Appliance Data Plate: It can be seen through the grill located below the control panel. Open the door to expose the grill. On double ovens, the plate is located behind the top grill.
Dacor Renaissance Wall Oven Service Guide Model Number Identification EORS30xxx Model Type Epicure Renaissance Oven Millennia Renaissance Oven = EOR = MOR Configuration Single Oven Double Oven =S =D Width 27 Inch 30 Inch = 27 = 30 Trim Finish Options Epicure: Stainless Steel, Chrome Trim Black Handle, Black Trim Black Handle, Stainless Trim = SCH =B = BK Millennia: Stainless Steel =S Page 4
Section 3 – Quick Diagnostic Test Section 3 – Quick Diagnostic Test Renaissance Wall Oven Quick ERC/Diagnostic Test Test for Upper and Single Ovens Test 1 Test Description Oven lights 2 3 Membrane keypad check Controller numeric keys 4 Cooling fan function 5 Bake element 6 Broil element 7 Convection element and convection fan 8 Door latch motor engaged 9 Door latch motor disengaged 10 Meat probe operation 11 Lock out 12 12/24 HR clock mode 13 12/24 HR cook mode 14 15 UPO settings C
Dacor Renaissance Wall Oven Service Guide Test for Lower Double Ovens Test 16 Test Description Cooling fan function 17 Bake element 18 Broil element 19 Convection element and convection fan 20 Door latch motor engaged 21 Door latch motor disengaged 22 RTD Test Page 6 Requirement Press #, BAKE for lower oven and then press the down key 10 times, then START. Unit will go into Sabbath mode with target temperature of 100 deg F. Check that cooling Fan is ON.
Section 4 – Troubleshooting Charts Section 4 – Troubleshooting Charts Voltage and Continuity Symptoms All the voltage test points will be at the relay board. No clock display While power is on check the following Voltages: 1) P3 pin 4 - P3 pin 5 = 5 VDC (check both relay and display board). 2) P3 pin 6 - P3 pin 7 = 12 VDC (check both relay and display board) If one the above voltages not present check connection to P3 connector. If cable is properly connected, then replace it.
Dacor Renaissance Wall Oven Service Guide Symptoms No elements cycling in ALL modes (cont.) Bake element only is not cycling during preheat, bake, conv bake, conv roast, self clean, HOLD Page 8 All the voltage test points will be at the relay board. 10) L1B - L2 = 240 VAC (Lower elements).
Section 4 – Troubleshooting Charts Symptoms Bake element only is not cycling during preheat, bake, conv bake, conv roast, self clean, HOLD (cont.) Broil element only is not cycling during Preheat, Bake, Conv Bake, Conv Roast, Broil, Conv Broil, and Self Clean Convection element only is not cycling during preheat and Pure Convection All the voltage test points will be at the relay board.
Dacor Renaissance Wall Oven Service Guide Symptoms Convection element only is not cycling during preheat and Pure Convection (cont.) Convection Fan does not run during Preheat, Conv Bake, Conv Broil, Conv Roast. Page 10 All the voltage test points will be at the relay board. 5) If above mentioned terminals do not read 240 VAC when suggested mode is running and the oven started cold then the convectionl relay is not cycling or is damaged. Replace the relay board. Upon replacement do the same test again.
Section 4 – Troubleshooting Charts Symptoms Convection Fan does not run during Preheat, Conv Bake, Conv Broil, Conv Roast (cont.) Cooling fan does not turn on at designated turn ON temperature Latch motor not running during Self Clean All the voltage test points will be at the relay board. 12) If connection is good, disconnect convection fan and measure the resistance directly. Resistance should be approximately 13 ohms across the terminals.
Dacor Renaissance Wall Oven Service Guide Symptoms Latch motor not running during Self Clean (cont.) No oven light only No heat in any cooking mode Oven sensor failure Failure Code U30/31 Latch switch circuit Page 12 All the voltage test points will be at the relay board. 7) If there is continuity, check resistance on these test points: 8) Check upper/single latch motor, Neutral - P11 Pin 1 = approximately 18 ohms. 9) Check lower latch motor, Neutral - P11 Pin 9 = approximately 18 ohms.
Section 4 – Troubleshooting Charts Membrane Continuity Test To test for non-functioning membrane touchpad, disconnect the membrane/touchpad ribbon connector from the ERC controller. The ribbon connector is numbered from 1 to 14 counting from the top down. Use an Ohm meter to test across the following test points. A reading above 5 Ohms across any of the test points listed below indicates the membrane is bad and needs to be replaced.
Dacor Renaissance Wall Oven Service Guide Section 5 – EOR-MOR Wall Oven Error Codes Displayed Error Message Error Condition Max/Min Bounds Max/Min Bounds Stored in EEPROM? Software Logic Description No Shorted Key Failure Control Errors C01 Shorted Key Failure A release of the key is not seen for two minutes C23 OCC Ambient Over Temperature 80°C No Control Board Ambient temperature is above 80°C. Oven shuts down with the cooling fans turns ON until the ambient temperature falls to 50°C.
Section 5 – EOR-MOR Wall Oven Error Codes Displayed Error Message Error Condition Max/Min Bounds Max/Min Bounds Stored in EEPROM? Software Logic Description Oven Errors U = UPPER OVEN / L = LOWER OVEN U20 / L20 Cook over temperature - 610°F Yes Center of oven cavity temperatures above the maximum bounds. U21 / L21 Clean over temperature - 890° Yes Center of oven cavity temperatures above the maximum bounds.
Dacor Renaissance Wall Oven Service Guide Section 6 – Temperature Offset Calibration Instructions Entering Calibration Mode 1) 2) 3) 4) Press and hold the “0” and “#” keys. The display will show the word “PASS”. Using the number keypad enter 6428 then press the Start key. The display will change and read “SLCE” “00”. Quickly move to step 4. Select the cooking mode that needs to be calibrated for example “BAKE“. Using the number keypad enter the new calibration offset for example “25”.
Section 7 – Wiring Diagrams Section 7 – Wiring Diagrams Page 17
Dacor Renaissance Wall Oven Service Guide Page 18
Section 7 – Wiring Diagrams Page 19
® The Life of the Kitchen.
