User Guide

E15
Exterior
The outside surface is precoated metal and plastic. Clean
the outside with mild soap and water; rinse and dry with
a soft cloth. Do not use any type of household or abrasive
cleaner.
Stainless Steel Surface
(Select Models)
The exterior should be wiped often with a soft damp cloth
and polished with a soft dry cloth to maintain its beauty.
Always wipe in the direction of the grain. There are also
a variety of products designed especially for cleaning and
shining the stainless exterior of the Microwave In-A-
Drawer
™
. We recommend that the cleaner be applied to a
soft cloth and then carefully used on the stainless exterior
rather than sprayed directly on to it. Follow package direc-
tions carefully.
Front Side Of The Drawer
Wipe the window on both sides with a soft damp cloth to
remove any spills or spatters. Metal parts will be easier to
maintain if wiped frequently with a soft damp cloth. Avoid
the use of spray cleaners and other harsh cleaners as they
may stain, streak or dull the door surface.
Touch Control Panel
If desired, the touch pads may be deactivated before
cleaning. See the Control Lock information on page 13
of this manual. Wipe the panel with a cloth dampened
slightly with water only. Dry with a soft cloth. Do not
scrub or use any sort of chemical cleaners. Close door and
follow directions on page 14 for turning Control Lock off.
Touch STOP/CLEAR.
Interior
Cleaning is easy because no heat is generated to the
interior surfaces; therefore, there is no baking and set-
ting of spills or spattering. To clean the interior surfaces,
including drawer sealing surfaces, wipe with a soft damp
cloth. DO NOT USE ABRASIVE OR HARSH CLEANERS OR
SCOURING PADS. For heavier soil, use mild soap; wipe
clean with a soft damp cloth. Do not use any chemical
oven cleaners.
Drawer Guides
Remove the food crumbs from the Drawer guides. Wipe
with a soft dry cloth in order to keep the Drawer opening
and closing smoothly.
Waveguide Cover
ATTENTIoN
The waveguide cover, located on the inside
top of the Microwave area, is made from mica, so it
requires special care. Keep the waveguide cover clean to
assure good microwave performance. Carefully wipe with
a soft damp cloth any food spatters from the surface of
the cover immediately after they occur. Built-up splashes
may overheat and cause smoke or possibly catch re. Do
not remove the waveguide cover.
Odor Removal
Occasionally, a cooking odor may remain in the Drawer.
To remove, combine 1 cup water, grated peel and juice of
one lemon and several whole cloves in a 2-cup glass mea-
suring cup. Boil for several minutes using 100% power.
Allow to set in the Drawer until cool. Wipe interior with a
soft cloth.
Cleaning and Care