User Guide

9
Planning the Installation
Installation Instructions
Electrical Specifications
IMPORTANT
• Preheat times and cavity temperature recovery times
will be increased slightly if operating on less than a
240 Vac circuit.
• This appliance is provided with electrical connection
leads in a flexible metal conduit. These leads may be
a smaller gage than the standard household wiring of
the dedicated supply circuit, but they are suitable for
connection to these circuits under the jurisdiction of
the National Electric Code, and/or the local inspection
authority.
• Locate the junction box so that the wiring may be dis-
connected without removing the oven from the wall.
It is the owner’s responsibility to ensure that a qualified
electrician performs the electrical connection of this appli-
ance. The electrical installation, including minimum supply
wire size, must comply with the National Electric Code
ANSI/NFPA 70 (latest revision) and local codes and ordi-
nances.
A copy of this standard may be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, Massachusetts 02269-9101
The correct voltage, frequency and amperage must be sup-
plied to the appliance from a dedicated, grounded, single
phase circuit that is protected by a properly sized circuit
breaker or time-delay fuse. If a time-delay fuse is utilized,
fuse both sides of the line (L1 and L2).
Model Type
Dedicated Circuit
Requirements
Total
Connected Load
Single 27”
240 Vac 60 Hz.,
4 wire*, 30 Amp.
dedicated
4.6 kW (19.5 Amp.)
Single 30”
Double 27”
240 Vac 60 Hz.,
4 wire*, 50 Amp.
dedicated
9.25 kW (38.9 Amp.)
Double 30”
* Two 120 Vac hot (L1 and L2), one neutral, one ground.
The above electrical ratings are for reference only. For the
exact ratings see the product data plate. See page 3 for
location.
Verify that all the parts are included. If any item is missing
or damaged, please contact your dealer immediately. Also
make certain that you have all tools and parts necessary to
ensure a proper installation before proceeding.
• Exhaust deflector
◊ 27” defector - PN 46050B
or
◊ 30” deflector - PN 46051B
• Mounting and exhaust deflector screw kit
◊ Single oven screw kit - four (4) 3/4” mounting
screws, four (4) 1 1/4” mounting screws and three
(3) exhaust deflector screws - PN 700486-1
or
◊ Double oven screw kit - Six (6) 3/4” mounting
screws, six (6) 1 1/4” mounting screws and three
(3) exhaust deflector screws - PN 700486-2
• Meat probe, one (1) - PN 72723
• Broiler grill and pan - PN 12157
Parts List
• Standard oven racks two (2) for a single oven, five (5)
for a double oven
◊ 27” standard rack - PN 72747
or
◊ 30” standard rack - PN 72713
• GlideRack™ oven rack, one (1)
◊ 27” GlideRack™ oven rack - PN 72948
or
◊ 30” GlideRack™ oven rack - PN 72949
• Stainless steel cleaner - stainless steel models only
PN A302
• Product literature