Installation Instructions Epicure ® Outdoor Grill Models: OB36, OBS36, OB52 OBS52, OBSB162 Tested in accordance with the latest edition of ANSI Z21.58 2006 ● cSa 1.6-2006 Standard for outdoor cooking gas appliances. IN CANADA: INSTALLATIONS MUST BE IN ACCORDANCE WITH THE CURRENT CAN/CGA-B149.1. NATURAL GAS INSTALLATION CODE CAN/CGA-B149.2. PROPANE INSTALLATION CODE AND/OR LOCAL CODE. Part No. 102032 Rev.
Table of Contents Before You Begin............................................................... 1 Important Safety Instructions........................................... 1 Important Information About Safety Instructions............... 1 General Safety Precautions.............................................. 2 Planning the Installation.................................................... 4 Product Dimensions.......................................................... 4 Location Planning - General...........
Important Safety Instructions warning If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. warning This outdoor cooking appliance is not intended to be installed in or on a recreational vehicle and/or boats. warning warning NEVER use this appliance as a space heater to heat or warm a room. Doing so may result in carbon monoxide poisoning and overheating of the appliance.
Important Safety Instructions WARNING 17. Keep items that could explode, such as aerosol cans away from the grill and burners. Do not store flammable or explosive materials in adjacent cabinets or areas. 18. Do not use towels or bulky cloth as pot holders. 19. To avoid the possibility of fire, do not leave the appliance unattended when in use. 20. DO NOT TOUCH ANY OF THE COOKING SURFACES DURING OR IMMEDIATELY AFTER USE.
Important Safety Instructions General Safety Precautions (continued) To reduce risk of fire, electric shock, serious injury or death when using your appliance, follow basic precautions, including the following: WARNING TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A GREASE FIRE: • SMOTHER FLAMES with a close-fitting lid, cookie sheet or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.
Planning the Installation 26" (660mm) OB52 and OBS52 9 1/8" (232mm) 52" (1321mm) 23 3/4" (603mm) 26 1/2" (673mm) 27 1/8" (689mm) 9 1/8" (232mm) OBSB162 23 3/4" (603mm) 26 1/2" (673mm) 27 1/8" (689mm) 16" (406mm) Cut-Out for Outdoor Grill Accessory Doors 21” (533mm) Door Depth: 1/4” (6mm) deep return on frame edge Door Model Width OBAD20 19 1/2” (495mm) OBAD36 35 7/8” (911mm) Width
Planning the Installation warning • • • This installation must conform to local codes or, in the absence of local codes, with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54, Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2. Gas and Electric Power Requirements • Prior to installation, the gas supply for natural gas or whole house LP installations must meet the specifications below.
Planning the Installation Location Planning - Enclosed Cabinets • Maintain all minimum clearances specified on pages 7 and 8. • For proper outdoor grill operation, provide a flat, level mounting surface with minimum 3/4” thickness. • • 10" (254mm) Min. to combustibles 1 1/4" (32mm) Min. to non-combustible 28 1/2" (724mm) To finished countertop Trim frame (accessory) All models are designed to allow installation in combustible or non-combustible base material structures.
Planning the Installation Location Planning - Enclosed Cabinets (continued) 6" x 6" (152mm x 152mm) Utility Cutout for OBSB162 6" x 7" (152mm x 178mm) Utility Cutout 6” (152mm) 7” (178mm) 25" (635mm) 3/8" (10mm)ø Both sides OB(S)36 - 33 1/2" (851mm) OB(S)52 - 49 1/2" (1257mm) 8" (203mm) Min. to combustibles above the countertop surface 1 1/4" (32mm) 2" (51mm) Cutout Dimensions - Top View OBSB162 16 1/8" (410mm) OB(S)36 - 36 1/2" (927mm) OB(S)52 - 52 1/2" (1334mm) 9" (228mm) Max.
Planning the Installation Location Planning - Cart Installations • Maintain all minimum clearances shown between the appliance and all surfaces behind and to the side of the appliance. • Allow 26 inches minimum in front to open and close the cabinet drawers. • For proper grill and drawer operation, use the outdoor grill and cart only on a level surface. • Side distances exclude optional shelves. Above the cooking surface, both sides: 3” (76mm) Min. to non-combustibles 10" (254mm) Min.
Installation Instructions warning • • • • Parts List Models OB36, OBS36, OB52 & OBS52: Before installing the appliance, make sure the electrical and gas (on tank-less installations) service meets the requirements specified in the Planning the Installation section of this manual. A Drip tray G Rotisserie rod and forks B Smoker box H Rotisserie motor This appliance must be installed by a licensed plumber or gas fitter when installed within the Commonwealth of Massachusetts.
Installation Instructions D Whole House Natural Gas or LP Regulator D D LP Cylinder Regulator OBS162, OB36, OBS36 (PN 72310) LP Cylinder Regulator OB52, OBS52 (PN 101578) F E G K H J L N P M 11
Installation Instructions Cart Installation Cabinet Installation warning warning To avoid an explosion hazard, do not connect the cart or appliance(s) to electrical power until after the gas supply system has been checked for leaks. important To prevent damage to the gas regulator, install the regulator only after the appliance is mounted in its permanent position in the enclosure. • With at least one person on each side of the unit, lift it up and lower it into the cabinet cut-out.
Installation Instructions Optional Side Shelf Installation 1. Install the front mounting bracket for the right side shelf. Use two (2) of the provided button head fasteners and two (2) lock washers. Tighten into place using a 5/32” allen wrench. 2. Slide the slot on the inside of the shelf over the pin on the mounting bracket. Pin 3. While holding the shelf in place, insert the pin on the back mounting bracket into the slot on the back side of the shelf. 4.
Installation Instructions Connecting the Gas Gas Connection - Natural Gas notes • Units equipped for use with natural gas ship with a regulator assembly with 3/4” pipe attached and an additional 3/4” nipple. • The regulator assembly is also equipped with a 3/4” to 1/2” reducer on the inlet side. 3. Install an approved flexible gas line from the regulator to the gas line shut off valve. Whole House LP Gas Connection 1.
Installation Instructions Final Assembly and Test Assemble the Grill Assemble the Side Burner - Some Models 1. Open the hood on the unit. 7. Put the burner heads on to the burner bases. Line up the slots on each head with the pins on the base so that it lies flat. Put the burner caps on top of the burner heads. Line up the slots on each cap with the pins on the base so that it lies flat. 2. Insert the drip tray completely into the slot on the front of the unit. 3.
Installation Instructions Final Assembly and Test (cont.) LP Cylinder Installation - Some Models warning • • The largest recommended LP cylinder size for the rollout tank shelf on the cart is five gallons. A five gallon portable liquid propane cylinder should be approximately 12 inches (305mm) in diameter and 18 inches (457mm) high,. It must be constructed and marked in accordance with the specification for liquid propane (LP) gas cylinders of the U.S.
Installation Instructions 2. With the tank shelf open, connect the power cord from the outdoor grill and the warming oven (if equipped with one) to the electrical outlet on the back panel inside the cart. Push to reset 6. If the second or third attempt to ignite the burner is not successful then turn all burner controls to the OFF position. 7.
Web Site: Phone: www.Dacor.com (800) 793-0093 Copyright © 2007 by Dacor Inc. All rights reserved.
