Installation guide

Installation Specifications
Verifying the Package Contents A
Oo
V
[sa B Be
* (3) mounting screws - PN 83569
« Wire rack with mounting hardware (OWD24 only) \
(1) PN 83619 (screw), (1) PN 83267 (clamp)
Installation Planning
Chassis
* A qualified technician must complete the installation of this built- E
in appliance. Proper installation is the customer's responsibility.
* Carefully check the location where the drawer is to be installed. 5/16”
The drawer should be placed for convenient access. Make (8 mm)
certain that electrical power can be provided in the selected
location. Install the warming drawer in wood cabinets only. * =
* Plan the installation so that all minimum clearances are met or
exceeded. Dimensions shown provide minimum clearances,
unless otherwise noted. Be certain that proper clearance is
provided for the drawer when it is in the open position.
Drawer open F
* The specified minimum cabinet depth and width must be
provided. The cabinet depth and width must completely enclose
the recessed portion of the drawer.
* Cabinet cutout dimensions must be used as indicated. All
contact surfaces between the appliance and the cabinet must
be solid and level. The drawer support platform must be flush Overall Dimensions - IWD/OWD Series
with the bottom edge of the cabinet cutout. Top View
* Make certain that you have everything necessary to ensure a
proper installation before proceeding.
Mounting
hole
40"
(101.6
cm)
*
Acustom
front
panel
is
required
for
IWD
u
ng
|
(iors.
series models and optional for OWD24. 120 Vac power cord
* An optional Epicure® style front panel kit
is available for model OWD24. a
Chassis without
drawer installed
** = OWD24 mounting holes
Drawer Face Dimensions Chassis Dimensions
(IWD/OWD Series) (IWD/OWD Series)
(D) (E) (F) (G)
(A) Dimension (C) Dimension
(B) Dimension Dimension | Dimension | Dimension | Dimension
Model pre Chassis Width cn ace Drawer Chassis Drawer Chassis
Face Height Depth Depth Height
IwD24 22 5/16” (56.7 cm) | 22 1/4” (56.5 cm) | 22 3/8” (56.8 cm)
8 15/16" 23 3/8" 23 13/16” 9 1/16”
WD27 25 5/16” (64.3 cm) | 25 1/4” (64.1 cm) | 25 3/8” (64.5 cm)
IWD30 28 5/16” (71.9 cm) | 28 1/4” (71.8 cm) | 28 3/8” (72.1 cm)
(22.7 cm) (59.4 cm) (60.5 cm) (23.0 cm)
11 7/8” 20” 18” 11 7/8”
OWD24 22 1/2" (57.1 em) | 22 1/2" (57.4 em) | 22 1/2" (57.1 em) | (39 5 om) 08cm) | (45.70m) | (02cm)
See following page for chassis dimensions for other models
dacor 3