Use and Care Manual

ManualsBrandsDacor ManualsMicrowave Oven1.1-cu ft Over-The-Range Convection Oven Microwave with Sensor Cooking Controls (Stainless Steel) (Actual: 29.93-in)

CLEANING AND CARE

FAN

The fan will automatically start when heat rises from

range surface units or burners and when convection,

high mix, low mix or the broil settings are used. This

protects the microwave oven from excessive tempera-

ture rise. The fan will stay on until the temperature

decreases. It cannot be turned off manually during

this time.

For other uses, select either high or low speed.

PRECAUTIONS FOR PROPER USE:

1. DO NOT leave range unattended while using high

temperatures. Automatic fan may start and provide

excessive air to the surface units. This may cause

spattering or boilover.

2. Avoid burning food.

3. Keep grease filters clean.

LIGHT

1. To replace light bulbs, first disconnect power to the

oven at the circuit breaker panel or by unplugging.

2. To release cover remove the screw on the light cover.

(See illustration.)

3. Replace bulbs only with 20 watt bulbs (part

#RLMPTA068WRE0) available from a Dacor

Authorized Servicer or parts distributor. Bulbs are

also available at most hardware stores or lighting

centers. DO NOT USE A BULB LARGER THAN

30 WATTS.

4. Close light cover and secure with screw removed in

step 2.

CAUTION: Light cover may become very hot. Do not

touch glass when light is on. Do not use light for long

time use such as a night light.

Light cover

Screw

Light bulbs

CHARCOAL FILTER

Charcoal Filter is used for No-vented, recirculated

installation. The filter should be changed every 6 to

12 months depending on use.

1. Disconnect power to the oven at the circuit breaker

panel or by unplugging.

2. Remove 3 screws that secure louver.

3. Pull the louver away from the oven.

4. Slide Charcoal Filter into position on support tabs.

5. Push louver back into place and gently snap tabs

into place by hand and replace the 2 screws to

secure louver.

OVEN LIGHT

Remove the louver per instructions 1-3 above and

charcoal filter, if used.

4. Slide the light cover forward and lift up.

5. Remove old light bulb and replace only with 20 watt

bulb (part #RLMPTA068WRE0) available from a

Dacor Authorized Servicer or parts distributor.

Bulbs are also available at most hardware stores

or lighting centers. DO NOT USE A BULB LARGER

THAN 30 WATTS.

6. Replace the oven light cover and charcoal filter, if

used; push louver back in place and replace the

louver mounting screws.

Louver

Oven light

Charcoal filter

Screw