User Guide

2
lo C a T i o n re q u i r e m e n T s
Your Dacor refrigerator can be recessed in an opening between
cabinets or installed at the end of a cabinet run using a side panel
to enclose the refrigerator.
IMPORTANT:
Observe all governing codes and ordinances.•
To ensure proper ventilation for your refrigerator, allow for a •
1/2” (1.25 mm) space at the top and behind the refrigerator.
Do not install the refrigerator in a location where the •
temperature will fall below 55°F (13°C).
Allow a minimum of 2 1/2” (64 mm) space between the side •
of the refrigerator and an oven or range.
The floor must be able to support the refrigerator’s weight of •
more than 600 lbs (272 kg), the door panels and the contents
of the refrigerator.
The area to the left and the right of the appliance must •
permit both doors to open to a minimum of 90°. Allow space
between the side of the refrigerator doors and a corner wall
for the handle and/or custom door panels.
Pr o D u C T Di m e n s i o n s
The depth from the front of the door (w/o door handles) to the •
back of the refrigerator chassis is 27” (686 mm).
The depth of the cabinet less the door is 24 1/4” (616 mm).•
The power cord is 60” (1524 mm) long.•
De s i g n sPeCifiCaTions
in s T a l l a T i o n sPeCifiCaTions
To o l s a n D Pa r T s
Make sure that you have the necessary tools and materials
available for a proper installation:
Phillips screwdriver set•
Slotted screwdriver set•
Copper tubing for the water line. Provide sufficient length to •
allow for a minimum of a 24” (610 mm) diameter service loop.
Compression nut and compression sleeve to connect to the •
water supply valve. A compression nut and sleeve are include
with the unit to connect the refrigerator side of the line.
Copper tubing cutter•
Level - 2’ (.6 m) and 4’ (1.2 m) recommended•
Appliance dolly able to support 700 lbs (317 kg) and •
adequate manpower to handle the weight of the appliance
Nut driver set or socket set•
Crescent wrench•
Cordless drill and assorted drill bits•
Plywood or cardboard to protect finished flooring•
Appropriate materials to cover and protect the home and its •
furnishings during installation
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
The height • from the top of the refrigerator to the floor with the
leveling legs in the down position is 70 1/8” (1781 mm).
The height from the top of the refrigerator to the floor with the •
leveling legs in the fully extended position is 71 1/4” (1810
mm) at the front of the unit. Add 2 1/2” (635 mm) for the
optional top trim kit.
The refrigerator width from edge to edge is 35 5/8” (905 mm).•