Installation guide
Installation
Instructions
Hanging
the
Blower
Assembly
WARNING
Do
not
use
screws
to
attach
the
duct
work
to
the
hood
exhaust
outlet.
Use
duct
tape
only.
Screws may
prevent
the
damper
flaps on
the
top
of
the
hood
from
opening.
1,
inside
the
exhaust
outlet
on
the
top
of
the
blower
assembly,
there
are
metal
or
plastic
damper
flaps.
The
flaps
close
to
help
prevent
back-drafts
when
the
blower
is
turned
off.
Remove
the
shipping
tape
and
make
sure
the
flaps
open
and
close
freely
before
pro-
ceeding.
Exhaust
a
outlet
Blower
assembly
2.
Lift
the
blower
assembly
up
and
put the
mounting
hole
on
the
top
over
the
mounting
bracket,
while
inserting
the
exhaust
outlet
into
the
end
of
the
duct
system.
Gently
lower
the
blower
assembly
onto
the
lip
of
the
mounting
bracket.
Slide
the
bottom
part
of
the
blower
assembly
between
the
two
“L”
brackets.
i
——
Insert
exhaust
outlet
into
end
of
duct
Mounting
bracket
"L"
brackets
3.
Insert
two
provided
machine
screws
into
the
two
holes
above
the
mounting
bracket
on
the
blower
assembly
and
tighten
into
place.
4.
Insert
two
machine
screws
through
the
front
of
the
mounting
bracket
and
tighten
into
place.
5.
Insert
two
machine
screws
through
the
side
of
both
“L”
brackets
and
tighten
into
place.
6.
Attach
the
end
of
the
duct
system
to
the
exhaust
out-
let
with
duct
tape.
8
decor.