Installation guide
Installation
Instructions
Electrical
Connection
Installing
the
Chimney
WARNING
«To
avoid
electrical
shock
or-fire
hazard,
make
sure
the
power-supply
at
the
fuse
or
junction
box
is
turned
off
before
proceeding
with
final
installation.
«Improper
connection
ofthe
hood
electrical
wiring
may
create
an
electric
shock
or
fire
hazard
and
may
result
in
damage
to.the
hoods
electrical
system.
«Do
not
ground
the
hood
to
the-neutral
(white)
power
supply
wire.
Connect
the
hood
ground
wire-to-a
separate,
properly
grounded-wire
installed
by
a
licensed
electrician.
Connect
the
power
supply
wires
to
the
wires
coming
out
of
the
top
of
the
hood
junction
box
on
the
blower
assembly:
1.
Connect
the
white
wire
from
the
hood
to
the
neutral
(white)
power
supply
wire.
z.
Connect
the
black
wire
from
the
hood
to
the
hot
(black)
power
supply
wire.
3.
Connect
the
green
and
yellow
wire
from
the
hood
to
the
house
ground
(green)
wire
from
the
junction
box.
Yellow/green
to
green
IMPORTANT:
Be
careful
not
to
pinch
the
electrical
wires
while
installing
the
chimney.
1,
Remove
the
protective
plastic
covering
from
both
pieces
of
the
chimney
assembly.
Do
not
remove
the
protective
tape
strips
from
the
inside
of
the
chimney.
They
protect
the
telescoping
pieces
from
scratching
during
installation.
Carefully
slide
both
sections
together
so
that
only
the
vents
on
the
top
section
show.
Hold
the
chimney
vertically
with
the
vents
up,
close
to
the
blower
assembly.
Connect
the
control
panel cable
on
the
chimney
to
the
cable
on
the
front
of
the
blower
assembly.
Connect
cable
ao
vis
®
Chimney
Continued...
decor
9