Installation guide

Planning the Installation
Cabinet Cut-Out (continued)
Support Platform
WARNING
The.top surface-of the support:platform must: be.installed
flush with the cutout:in the front.of the cabinet or wall
and any trim. Failure to-install the platform properly
may cause the exhaust-vent:to deform and/or become
obstructed. An obstructed exhaust.area may cause the
oven to malfunction. See below.
Provide a platform within the cabinet to support the oven.
A properly supported piece of 3/4” (19mm) thick plywood is
recommended.
All contact surfaces between the appliance and the cabi-
net, including the support platform, must be sturdy, straight
and level. The oven cannot be leveled after it has been
installed.
| +— Oven door
(do not block)
Exhaust deflector
(do not bend)
fo |
oe Deformed sheet metal
- blocking vent
Support platform
Exhaust vent
(do not block)
Sheet metal on
bottom of oven
Cabinet front
or wall
RIGHT
Support Platform Configuration
8) dacor