Installation guide

Re-installing the Drawer

Pull the drawer slides all the way out of the drawer

opening.

Gently lower the drawer between the extended slides

until it is suspended by them.

Slide the back of the drawer mounting brackets under

the drawer mounting clips on the slides.

Push one side of the drawer down onto its locking tab,

until the tab locks into place.

Repeat the same process on the opposite side.

Gently open and close the drawer to make sure that it

is properly installed.

STEP 3: Slide mounting

bracket under clip on slide

Towel Rack Installation

(OWD24 Only)

Model OWD24 is designed so that it can be used as a

towel warmer if desired. Other models are not equipped for

this application. To use model OWD24 as a towel warmer,

you must install the towel rack included with the unit in the

bottom of the drawer.

To install the towel rack:

1. Open the drawer completely.

2. Insert the towel rack into the drawer in the orientation

shown below.

STEP 4" Push front

of drawer down until

tabs lock into place

Slide

Clip on slide

Use the clip and screw included with the rack to attach

it to the back of the drawer face as shown below. There

is a hole for the screw in the back of the face plate

near the bottom.

8 _mC_