Installation instructions

13
Installing the Holding Brackets
IMPORTANT: Placing the holding brackets above, below, or
off the centerline will cause alignment problems during final
installation.
1. Mark the holding bracket’s horizontal centerline 2 1/8
inches (54 cm) below the top of the hood.
2. Next, mark the holding bracket’s two vertical center-
lines. Refer to the table and image on right.
3. Measure and mark the “F” distance.
4. Lay the bracket against the wall, and align the
screwholes with the horizontal centerline.
• Make sure the anchors and/or screws being used are
strong enough to support the hood.
• Make sure drywall installations are properly
reinforced.
5. Mark the two holes in the bracket.
6. Drill those two holes for screws or anchors.
7. Attach the brackets securely to the wall.
2 1/8”
Bracket
location
Bracket
location
Hood
location
F F
Holding Bracket Cenerline Distance
Models F
RNHP3012, RNHP3018 12 1/2 in (31.75 cm)
RNHP3612, RNHP3618 7 1/8 in (18.1 cm)
RNHP4812, RNHP4818 17 in (43.18 cm)
Hood
location
Step 4
Marking the Centerlines and Brackets
block
Installation Instructions
C
L
C
L
C
L
Mounting
Attaching the Brackets to the Wall