Installation instructions

24
Verifying the Setup
1. Make sure the main power switch is OFF. (Refer to the
figures at right.)
2. Turn power ON at the circuit panel or fuse box.
3. Then turn the main power switch ON. The control panel
will flash several times during startup.
4. Insert the filters gently:
Be careful not to scratch the back of the grease channel!
• Raise the front edge into the clip, and press forward.
• Lift the rear edge up and above the grease channel.
Use care not to scratch the grease channel or other
parts of the hood or filters.
• Set the rear edge onto the grease channel.
5. Press the LIGHTS button. Verify that all the lights
illuminate.
6. Press the LIGHTS button again
to turn the lights to the low setting.
7. Press the LIGHTS button again to turn the lights off.
8. Press the FAN button once and release. Verify that one
light is showing on the fan speed indicator and that the
fan is on at low speed.
9. Slowly touch and release the FAN button three times.
Verify that with each touch, the number of lights rises
and that the fan speed increases.
10. Press the FAN button again to turn the fan OFF
If the Hood Fails to Function Correctly:
1. Verify that power is supplied to the hood.
2. Remove the right filter, find main power switch behind
the front panel, and confirm the main power switch is
ON.
3. Check the electrical connections to ensure that the
installation has been completed correctly.
4. Repeat the above steps.
• If the hood still does not work, contact Dacor Distinctive
Service at [phone] ex. 2822. Do not attempt to
repair the appliance yourself. Do not attempt to repair
the appliance yourself. Dacor is not responsible for ser-
vice required to correct a faulty installation.
Installation Instructions
Feature button pamel
Detail of main
power switch
Filter
ON
OFF
FAN
button
LIGHTS
button
TIMER
button
Location of
Main Power Switch
Main Power Switch
Feature Button Panel
Detail of front
filter clip
Grease channel
FRONT
FRONT
REAR
FRONT
Light