Installation guide

Product Specifications
Electrical Specifications
* It is the owner’s responsibility to ensure that a licensed
electrician performs the installation of the electrical sup-
ply for this appliance. The electrical installation, includ-
ing minimum supply wire size, must comply with the
National Electric Code ANSI/NFPA 70 (latest revision)
and local codes and ordinances.
A copy of this standard may be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, Massachusetts 02269-9101
*« The correct voltage, frequency and amperage must be
supplied to the appliance from a dedicated, grounded,
single phase circuit that is protected by a properly sized
circuit breaker or time-delay fuse. If a time-delay fuse is
utilized, fuse both sides of the line (L1 and L2).
* Preheat times and cavity temperature recovery times
will be increased slightly if operating the unit with less
than a 240 Vac circuit.
*« This appliance is provided with electrical wiring in a
flexible metal conduit.
Product Dimensions
Model
Dedicated
Circuit
Total
Connected
Number
Requirements
RO130S
RO130B
240
Vac
60
Hz,
See
product
data
4
wire*,
30
Amp.
ROV130B
RO230S
RO230B
240
Vac
60
Hz,
See
product
data
4
wire*,
50
Amp.
ROV230B
* Two 120 Vac hot (L1 and L2), one neutral, one ground.
All tolerances: +1/16 (+1.6 mm), unless otherwise stated.
Model (A) . . (E) Control
Number Overall Onassis (©) overall (D) Bhassis Panel
Width g g Overlay
RO130S
RO130B 29 7/8 28 3/8 27 5/8” (70.2 26 5/8 1
(75.9 cm) (72.1 cm) cm) (67.6 cm) (2.5 cm)
ROV130B
RO230S
29 7/8” 28 3/8” 49 7/8” 49” 7/8”
RO230B (75.9 cm) | (72.1 cm) (126.7 cm) | (124.5 cm) (2.2 cm)
ROV230B
(F) Utility | (G) Utility (H) Utility | (J) Control :
Cutout Cutout Cutout Panel ens SIs
Width Height Depth Depth P
All Models 6 1/4” 4 3/4” 7 3/4" 1 3/16” 23 5/8”
(15.9 cm) (12.1 cm) (19.7 cm) (3.0 cm) (60.0 cm)
4 dacor