Planning Guide

PLANNING

GUIDE

All specications subject to change without notice. www.dacor.com Ph. 800.793.0093

HRTP Dimensions

Chassis Width

Model A

HRTP366 35 ” (91.1 cm)

HRTP486 47 ” (121.6 cm)

Heritage

36”, 48” Wide

Slide-In Gas Rangetop

Doc #: PGH-HRTP.01 Revised 22 May 2018 Page 1 of 3

All tolerances: ±¹/₁₆” (±1.6 mm), unless otherwise stated.

HRTP366, HRTP486

WARNING

• Observe all governing codes and

ordinances during planning/installation.

(Contact the local building department

for details.)

• The rangetop must be installed as

instructed in this guide.

Model B C

HRTP366 36” (91.4 cm) 36” (91.4 cm)*, 42” (106.7 cm)**

HRTP486 48” (121.9 cm) 48” (121.9 cm)*; 54” (137.2 cm)**

* Minimum ** Recommended

Note Description

1 Measured from top of grate to combustible surface.

See Cabinet/Countertop Cutout Dimensions, Pgs. 3 – 4.

Not applicable for cabinets more than a horizontal distance

of 10” (25.4 cm) from edge of rangetop.

PAGE 1
HRTP366, HRTP486 Doc #: PGH-HRTP.01 Revised 22 May 2018 Page 1 of 3 All tolerances: ±¹/₁₆” (±1.6 mm), unless otherwise stated. Heritage® 36”, 48” Wide Slide-In Gas Rangetop HRTP Dimensions PLANNING GUIDE WARNING • Observe all governing codes and ordinances during planning/installation. (Contact the local building department for details.) • The rangetop must be installed as instructed in this guide. Chassis Width Model B C HRTP366 36” (91.4 cm) 36” (91.4 cm)*, 42” (106.7 cm)** HRTP486 48” (121.
PAGE 2
HRTP366, HRTP486 Page 2 of 3 All tolerances: ±¹/₁₆” (±1.6 mm), unless otherwise stated. Heritage® 36”, 48” Wide Slide-In Gas Rangetop PLANNING GUIDE Cabinet/Countertop Cutout Dimensions Model B (Cutout Width) D (Hole Offset) HRTP366 36” (91.4 cm) 16 5/8” (42.2 cm) HRTP486 48” (121.9 cm) 20-¹³/₁₆” (52.9 cm) NOTE: The power cord and gas-supply conduit may be routed through the bottom or back of the rangetop chassis. All specifications subject to change without notice. www.dacor.com Ph. 800.
PAGE 3
HRTP366, HRTP486 Page 3 of 3 All tolerances: ±¹/₁₆” (±1.6 mm), unless otherwise stated. Heritage® 36”, 48” Wide Slide-In Gas Rangetop PLANNING GUIDE Cabinet and Countertop Layout (with downdraft vent) Model B (Cutout Width) D (Hole Offset) E (Downdraft Vent Cutout) HRTP366 36” (91.4 cm) 16 5/8” (42.2 cm) 33 1/2” (85.1 cm) HRTP486 48” (121.9 cm) 20 ¹³/₁₆” (52.9 cm) 43 1/2” (110.