Instruction Manual

DACS LTD, Stonehills, Shields Road, PELAW, Gateshead, Tyne and Wear NE10 OHW
Tel:[phone] | Fax: [phone] | www.dacs-audio.com | [e-mail]
1. IEC inlet factory set to 240V for
110V supply remove fuse holder
and rotate so that 110V legend is
on top/correct way up
2. Electronically balanced
output for unbalanced
operation connect either
pin 2 or 3 to 0V
3. (Non Phantom) Input
for Microphones that do
not require power eg
valve mics, dynamic mics
4. (Phantom) Input with
48V phantom power on
pins 2 and 3
5. Audio 0V, isolated
from mains earth
12. Power Switch
9. Unique tri segment LED meter - PPM ballistics variable
intensity LED illumination - Green illuminates at -15dBM,
Yellow at +5dBm and Red at +13 dBm
10. Ultra bright overload light illuminates when clipping
occurs (overload ca +22dBm) and remains on for a few
seconds
11. Phase reverse switch, Up for in phase, dow to reverse
6 7 8
6. Stepped gain in 6dB steps from 20dB to
62dB
7. Gain Trim allowing extra gain of 10dB scale
to the hour and half hour for easy repeatability
(6 o’clock = 0dB. 3 o’clock= +10dB
8.Bass roll off filter - flat and 30Hz or 80Hz the
filter curver has been selected to minimise the
effect of frequencies above cut off point