User's Manual

User’s Manual: ABC-220 Series (SL)
Revision 1.1
Elisync Technologies LLC.
-14-
5. System Setup Method
5.1 Wireless PAIRING Setup
1) In hand control, press and hold the USER button
for 3 seconds to go into pairing mode. The RED
INDICATOR light will begin to flash in 1 second
interval. In pairing mode, the hand control
continuously transmits its unique ID.
Press the USER button to stop the RED
INDICATOR light flashing and exit from pairing
mode.
2) In control box, press and release the PAIRING
button to go into pairing mode. The control box
goes into pairing mode and tries to finds any
available ID transmitted from hand control. The
pairing mode continued 2~5 seconds depending on
wireless condition of hand control to be paired.
Unplugging and plugging the AC power cord
also make control box go into pairing mode.
This method is useful when you cannot access
the PAIRING button easily when the control
box is attached under the bed.
3) When control box finds any available ID, the
pairing process is done and the GREEN
INDICATOR light is turned ON continuously.
 Electronic ID
Each hand control has unique, factory-lasered 16-bit
registration ID number that provides an absolutely
unique identity, which guaranteed no two hand control
alike.