INSTRUCTION MANUAL DP-SP22 DP-SP21 DP-SP20 PLASMA MONITOR (DISPLAY) SPEAKER Thank you for purchasing the Daewoo Electronic Plasma Display Speakers. These speakers are specifically designed only for the Daewoo Plasma Display. To ensure the safe operation of the unit, please read these instructions before installing.
TABLE OF CONTENTS 1. Check for enclosed parts ............................ 2 2. Important Safety Instructions ...................... 3 3. Assembly Instructions .................................
PLASMA DISPLAY SPEAKER SPEAKER 1.
2. IMPORTANT SAFETY INSTRUCTIONS PLEASE FOLLOW THESE INSTRUCTIONS FOR YOUR SAFETY PLEASE KEEP THESE INSTRUCTIONS FOR YOUR SAFETY AND TO PREVENT ANY DAMAGE TO THIS UNIT. WARNING : Disregarding these instructions can result in serious injury. WARNING CAUTION CAUTION : Disregarding these instructions will result in the mistreatment of the unit and can result in injury or damage to the unit. Do not leave out any part when assembling. Please install all parts as indicated.
PLASMA DISPLAY SPEAKER * PLEASE FOLLOW THESE SAFETY PRECAUTIONS WHEN INSTALLING OR HANDLING When assembling, be sure to use the enclosed parts and make sure all parts are tightly screwed as instructed. Please be careful not to stain the speakers with any gas or oil. (Failing to do so will cause the speakers to vibrate and unable to produce clear sound.) (Doing so will change the outer appearance) Do not place the speakers near heating units. Do not place the speakers in a humid or dusty place.
3. ASSEMBLING INSTRUCTIONS USING SPEAKERS WHEN ATTACHED TO THE PLASMA DISPLAY 1 ATTACHING VIBRATION ABSORBENT SPONGES TO SPEAKERS .Clean the surface with soft, lint-free cloth .Attach the sponge to the side of the where sponges will be attached. speaker that will be attached to the plasma display. 5mm Note Please leave a 5 mm space on the top and bottom when attaching. Do not cover the entire side with the sponge as shown in the picture above. 5mm 2 INSTALLING FIXED BRACKETS TO SPEAKERS .
PLASMA DISPLAY SPEAKER 3 INSTALLING SPEAKERS TO THE PLASMA DISPLAY .Place a protective covering over the surface you will be working on and lay the plasma display as shown below. S P E A K E R .Take the speakers with fixed brackets to the back of the plasma display. Place the hooks onto the fixed brackets to the squared holes in the back of the plasma display. Hooks .Now tightly secure the hooks with the M5 screws. Note .Please be sure to secure the screws to avoid any shaking or looseness.
4 CONNECTING SPEAKER WIRES .Take the speaker wire(2) and use the red cord to connect to and fro (+) inputs, and use the black cord to connect to and fro (-) inputs. Note .Please be sure to connect red cord with (+) and black with (-); otherwise, speakers will not produce clear sounds. .Please retain the left over accessories.
PLASMA DISPLAY SPEAKER USING SPEAKERS ON ITS OWN STAND 1 INSTALLING SPEAKERS TO ITS OWN STAND. Please be sure to have the vibration absorbent sponge onto the side of the speaker where the stand will be attached. .Use a coin to secure Coin the special screws (round head screws) tightly. Stand Note .To avoid loose fitting, please be sure that screws are secured tightly. Otherwise, vibrating or distorted sounds may be produced. 2 CONNECTING SPEAKER WIRES. .