Electronics DVD PLAYER INSTRUCTION MANUAL DV-900

8
BEFORE OPERATION
SECURITY
Before operation, check if the voltage of the unit is in line with the local voltage.
Hold the plug to disconnect it from the mains outlet. Do not pull the power cord.
When the plug of the unit is connected to the mains outlet , the unit will be still
connected to AC even if the power is turned off.
Disconnect the plug as soon as liquid or objects enter the unit. The unit can not be
used until being checked by experts.
Do not open the cabinet as laser rays employed by the unit may damage eyes. Any
servicing should be done by qualified service personnel.
PLACEMENT
Put the unit where ventilation is good enough to prevent overheating.
Never put the unit in direct sunlight or near heat sources.
Put the unit horizontally, never put any heavy object on the unit.
To protect the pickup, do not put the unit where there is dust. If there is dust on
the pickup, use a cleaning disc to clean it. Paying particular attention to the
operating instructions of the cleaning disc.
CONDENSATION
Moisture will appear on the pickup lens in the following cases:
The unit is suddenly moved from a cold place to a warm place.
The unit is put in a room with a heater, or in cold air from an air-conditioner.
Using the unit in a humid place. In these cases, the unit can not work. Unload the
disc and leave the unit on for about one hour to evaporate the moisture.
CLEANING
Use a soft cloth with a little neutral detergent to wipe the cabinet, panel and
controls.
Never use abrasive paper, polishing powder, solvent like alcohol or gasoline.
HANDLING DISC
CLEANING DISC
To keep the disc clean, do not touch the playsides of the disc.
Do not attach paper or tape to the disc.
Keep the disc away from direct sunlight or heat sources.
Store the disc in a disc case after playback.
Before playback, wipe the disc outward from the centre with clean cloth.
Do not use any type of solvent such as thinner, benzine, commercially available
cleaners or antistatic spray.