Operation Manual

Amplifier Section
- Continuous minimum sine wave RMS power
output into 4 ohms from 35Hz to 160Hz with no
more than 10% total harmonic distortion : 50W
- Frequency response : 35Hz ~ 160Hz
- Input sensitivity / impedance ( 55Hz )
Low level input(RCA) : 500mV / 15kohms
- Power requirements(Option) :
AC 110V or 120V or 127V or
220V or 230V or 240V (50/60Hz)
- Power consumption : 75Watts
Speaker driver
- Woofer diameter 6.5"(165mm)
- Frequency range 50Hz~5KHz
Dimensions (W x H x D) /Weight
200 x 360 x 275mm / 6.27Kg
Included Cable : RCA Cable 3m 1EA
Specifications are subject to change without notice.
43
Although the subwoofer can be installed in almost any location within the room, including next to an
audio component system, deep bass reproduction is enhanced when it is installed in a corner or
near a wall.
Because the propagation characteristics of low bass in music are omnidirectional, only one
subwoofer may be sufficient for bass enhancement.
CONNECTIONS
Caution!
Before making the connections and avoid damage to the amplifier or receiver and/or subwoofer
When connecting the subwoofer to an amplifier or receiver(not include), use the RCA
Cable(Provided with subwoofer) with a dedicated subwoofer jack.
SUBwoofer SPEAKER PLACEMENT
SPECIFICATIONS
Satellite speakers
Dimensions (W x H x D) /Weight
Front/Rear : 102x161x90mm / 470g x 4EA
Center : 300x102x90mm / 1.0Kg x 1EA
Input power : 30 W / each
Impedance : 6 ohms / each
Included Cable
Front : Red/Black 3m 2EA
Center : Blue/Black 3m 1EA
Rear : White/Black 15m 2EA
42
1. MAIN POWER ON/OFF SWITCH(Option for Europe)
- Push the switch to ON position to switch on the main power.
- Push the switch to OFF position to switch off the main power.
2. VOLUME with POWER ON/OFF
The subwoofer volume level increase or decrease.
- Rotate clockwise the volume control to turn on the active subwoofer system and volume level increase.
- Rotate countclockwise the volume control to volume level decrease and turn off the active subwoofer system .
3. PHASE(0
, 180 )
The phase relationship between the subwoofer and main speakers may vary depending on crossover
frequency selected and the distance between the subwoofer and the main speakers.
While listening to music with strong bass content, move the phase switch between the 0 and 180 position.
Leave the switch in the position that provides the strongest bass output.
4. AUDIO INPUT
Connect the audio source such as amplifier or TV.
5. AC CORD
Connect to a AC power outlet.
CONTROLS
Option
Active Subwoofer System(DA-115) Active Subwoofer System(DA-115)
Others