Washing Machine Instruction Manual DWD-MI*/DWD-FI* ■ Dear Customer, Firstly, many thanks for your preference in the purchasing of Daewoo product. The product is made in ITALY with the finest materials, comply with RoHs and REACH regulations with a particular focus on human health and the environment.
DWD-M_DWD-FI.
YOUR CONTRIBUTION TO ENVIRONMENTAL PROTECTION DISPOSAL OF PACKAGING The packaging has the purpose to protect appliance from damage that might occur during the transportation. The materials used for packaging are recyclable, so selected on the basis of respect for the environment and ease of disposal with aim of material reintegration to the production cycles.
SAFETY INSTRUCTIONS AND WARNINGS This washing machine complies with current safety standards. However, improper use can cause damage to persons and/or property. Before using the machine for the first time, carefully read this manual. It contains important instructions for safety, usage and maintenance of the washing machine. In this way self injury and damage to the machine is avoided. Keep the instruction manual and also pass it onto any other users.
• To connect the washing machine to the water supply using only new hoses. Do not use old water inlet hoses. Changes to the washing machine cannot be made if not specifically authorized by the manufacturer. CORRECT USE Do not install the appliance in places exposed to frost. Freeze might rupture or burst. Furthermore, at temperatures below zero the electronics can not function properly.
DESCRIPTION OF MACHINE This appliance meets all modern requirements for effective treatment of laundry with reduced consumption of water, electricity and detergent. Its innovative system permits full use of detergent and reduces water consumption, resulting in energy savings.
INSTALLATION GENERAL INFORMATION The washing machine can be installed in any place on condition that: • is protected from the bad weather; • the ambient temperature is not lower than 3 ° C; • the cables and hoses at the back of the machine are not crushed; • the power cord is accessible in case of any maintenance. Once unscrewed the screws pull out the locking screws including a bushing and spacer as shown in Figure 2. EN Figure 2 N.B.
Figure 4 vibrations, they should tighten by the ring nut and/or nut on the foot until it locks as shown in WATER SUPPLY CONNECTION The water inlet hose must be connected to a tap of cold water with a 3/4” threaded mouth. Use only the supplied water inlet hose, avoiding the use of old hoses, or hoses used previously. N.B. the hose is already complete with rubber gasket, if this is missing, the tube must not be used.
Figure 5b shows the connection to the hot water tap, this option is only available on request. Figure 5b hot water Example of installation Figure 7 EN cold water N.B. It is not recommend using extension on the drain hose. Make sure that the domestic hot water supply temperature does not exceed 55°C to avoid damage to the laundry and washing machine. For the inlet hose only use the supplied.
Make sure the plug is always accessible to unplug the machine from the mains. The electrical power system must be designed according to VDE 0100. It is recommend to not connect in any case the machine with extension cords multiple power sockets, etc to avoid overheating To increase security VDE, in the directive DIN VDE 0100 in section 739, it is recommended to install a circuit breaker (RCD) with a tripping current of 30 mA (DIN VDE 0664).
CONTROL PANEL EN *Available exclusively on the version of DWD-MI*/DWD-FI* model DESCRIPTION OF COMMANDS 1. PROGRAMME SELECTION DIAL The dial is used to select a desired programme and to turn the machine OFF. It can be rotated in clockwise and counterclockwise for a fast and easy selection of programme. 2. TEMPERATURE REGULATING DIAL This dial allows for the adjustment of the temperature. To change setting rotate the dial to the desired temperature. 3.
5. PREWASH AND SOAK FIRST USE This key allows for the selection of prewash or soak function. Upon each press of the button the LED indicator changes state There are three possible combinations which are: Before the regular use it is necessary to make a wash cycle with detergent, no laundry and setting the temperature to 60°C with cotton programme.
WASHING PROGRAMMES DURATION AND OPTIONS The programme intensive 60 °C and 40 ° C are the program and , used for the evaluation of the product performance, is the most EN of cotton laundries The actual values may differ from those indicated depending on the water pressure, its the power voltage and of the additional functions selected. Programme Consented temperatures Spin speed Laundry. 1-Cotton from to 90°C.
Programme Consented temperatures Spin speed Laundry.
ECO-DESIGN REFERENCE Residual Humidity (%) Total Energy Consumoption (kWh) Total water Consumption (lt) ITWASH type DAWOO model Water suply pressure (kPa) Standby Watt Programme time (min.) On Off EES610D DWD-MI1011 50 - 800 0.63 0.08 134 158 148 xxx xxx xxx 0.45 0.79 0.65 29.4 30.4 38 EES612D DWD-MI1211 50 - 800 0.63 0.08 134 158 148 54 53.6 53.7 0.45 0.79 0.65 29.4 30.4 38 EES710D DWD-FI2011 50 - 800 0.65 0.08 135 157 156 59.2 59.5 58.8 0.53 0.89 0.
PRECAUTIONS AND ADVICE WASHING RECOMMENDATIONS • Do not allow children or disabled to use the washing machine without supervision. • Do not allow children to play with the washing machine. • Load the drum within the limits indicated in the initial pages. • For each fabric it is important to follow the washing instructions on the label. • Make sure that there are no coins, pins, etc in the pockets of clothes for washing.
DOOR GASKET When washing some objects from over-folded clothes, or not removed from the laundry (paper clips, buttons, nails, pins) can break off and settle in the folds of the door gasket. It is a good habit to check the folds of the door gasket and remove any foreign objects which with time could cause serious problems to the washing machine. Where there will be prewash, detergent must be deposited in the compartment on the left side (marked I). EN The basin on the right is used for fabric softener.
For the amount of detergent, always check the DETERGENT POWDER make sure that the detergent can be poured into the basin. Detergent powder is more aggressive than the liquid and undoubtedly less advanced in some respects. It is prepared usually with components rather strong; The manufacturer also through particular substances (enzymes) which destroys the dirt detaching from the laundry, but does exert any abrasion on the fabric.
only at temperatures above 50°C, as in the liquid detergent there is no sodium perborate, but the optical bleaching agent that works well only beyond a certain temperature. Recommended temperature cold - 90°C SOFTENER The softener is very high concentrate, which them soft. It should be used sparingly or diluted with water, 50% and more. It facilitates ironing of clothes washed. The fragrances are due to different essences added to the detergent and do not in any way impair the ability of cleaning product.
MAINTENANCE CABINET To maintain the shininess of the washing machine cabinet over time it must be cleaned with warm water. Cleaning is recommended with soft cloth without using any detergent. DETERGENT DRAWER To avoid deposits formating it is necessary to rinse well the detergent drawer with water. It can be extracted from the housing by pressing on the area encircled in Figure 6. N.B If the drain pump is clogged, substantial quantity of water could be in the machine (max. 25l).
To stop the flow: Tighten the drain filter. When no more water comes out: DETERGENT DRAWER CLEANING Having removed the detergent drawer, take away the vent steam plate as shown in photo below. EN Unscrew the entire filter. Clean the filter. Verify that the drain propeller rotates easily. Remove any debris and clean the inside if there should be any. Replace the drain pump filter and screw it firmly. ! Warning! If the filter is not reinserted or screwed tightly, the water could spill from the machine.
POSSIBLE REMEDIES The vast majority of failures and faults that occur in daily use of the machine can be eliminated personally. In many cases time and costs could be saved without necessarily having to contact The manufacturer srl authorized technical service centre. The following table will aid to identify and possibly eliminate the causes of failure/malfunction. However, note that: ! Repairs executed incorrectly can seriously threaten the safety of user.
Problem LED number 2 and 4 flash (LED model) or F5 is displayed (Display model). LED number 1, 2 and 4 flash (LED model) or F6 is displayed (Display model). The door does not open LED Alarm ● o ● o ● o ● ● LCD Alarm Possible Solution F5 • Switch off and then switch on the washing machine. If the fault persists contact an authorised service centre. F6 • Switch off and then switch on the washing machine. If the fault persists contact an authorised service centre.
SPARE PARTS AND SERVICE REPAIR For any repairs, contact authorised The manufacturer Ltd technical support service centre. Always communicate model and serial number of the appliance printed on the rating label. The data plate is also visible on the door opening, in the upper part. SERVICE MODEL:DWD-MI*/DWD-FI* 04300025 PNC 24 DWD-M_DWD-FI.
PRODUCT FICHE Designing Excellence ■ Supplier : DONGBU DAEWOO ELECTRONICS ■ Model : DWD-MI1011 ■ Capacity : 6,0 kg ■ Energy efficiency class : A++ ■ Energy consumption 170 kWh per year, based on 220 standard washing cycles for cotton programmes at 60 °C and 40 °C at full and partial load, and the consumption of the low-power modes. Actual energy consumption will depend on how the appliance is used. ■ Energy consumption : 0.
PRODUCT FICHE Designing Excellence ■ Supplier : DONGBU DAEWOO ELECTRONICS ■ Model : DWD-MI1211 ■ Capacity : 6,0 kg ■ Energy efficiency class : A++ ■ Energy consumption 174 kWh per year, based on 220 standard washing cycles for cotton programmes at 60 °C and 40 °C at full and partial load, and the consumption of the low-power modes. Actual energy consumption will depend on how the appliance is used. ■ Energy consumption : 0.
PRODUCT FICHE Designing Excellence ■ Supplier : DONGBU DAEWOO ELECTRONICS ■ Model : DWD-FI2011 ■ Capacity : 7,0 kg ■ Energy efficiency class : A++ ■ Energy consumption 194 kWh per year, based on 220 standard washing cycles for cotton programmes at 60 °C and 40 °C at full and partial load, and the consumption of the low-power modes. Actual energy consumption will depend on how the appliance is used. ■ Energy consumption : 0.
PRODUCT FICHE Designing Excellence ■ Supplier : DONGBU DAEWOO ELECTRONICS ■ Model : DWD-FI2211 ■ Capacity : 7,0 kg ■ Energy efficiency class : A++ ■ Energy consumption 194 kWh per year, based on 220 standard washing cycles for cotton programmes at 60 °C and 40 °C at full and partial load, and the consumption of the low-power modes. Actual energy consumption will depend on how the appliance is used. ■ Energy consumption : 0.
PRODUCT FICHE Designing Excellence ■ Supplier : DONGBU DAEWOO ELECTRONICS ■ Model : DWD-FI5211 ■ Capacity : 8,0 kg ■ Energy efficiency class : A++ ■ Energy consumption 200 kWh per year, based on 220 standard washing cycles for cotton programmes at 60 °C and 40 °C at full and partial load, and the consumption of the low-power modes. Actual energy consumption will depend on how the appliance is used. ■ Energy consumption : 0.
PRODUCT FICHE Designing Excellence ■ Supplier : DONGBU DAEWOO ELECTRONICS ■ Model : DWD-FI5411 ■ Capacity : 8,0 kg ■ Energy efficiency class : A++ ■ Energy consumption 200 kWh per year, based on 220 standard washing cycles for cotton programmes at 60 °C and 40 °C at full and partial load, and the consumption of the low-power modes. Actual energy consumption will depend on how the appliance is used. ■ Energy consumption : 0.
ABOUT THIS MANUAL VISION CREATIVE. INC. 서울 종로구 통의동 6번지 이룸빌딩 4층 담 당 B.MODEL 정세훈 님 DWD-MI*/DWD-FI* B R A N D DAEWOO BUYER COUNTRY 규 언 격 어 영문 MEMO 접수 :(총 24p) 영문 15.04.17_표지(1p) 15.04.28_표지,6,8,10~15,18,19,20,22,23(14p) 15.04.30_표지,6,7,8,9,10,11,17,18,20,23,24(12p) 15.05.12_25~30(6p) 15.05.27_15(1p) DWD-M_DWD-FI.