Service manual

34
2-3 Spin Sequence
1) Water discharge
1It is done according to functional organization 3-5, water discharge sequence.
2) Balanced spin
1Depending on the amount of water, 3 steps of unbalance checks are done. If the criteria is satisfied, then it
advances to the next stage, spin R.
2Spin B refers to the unbalance detection area at 350 rpm. If the amount of unbalance exceeds the reference value,
then it turns back to the textile attachment region.
3Press the pause button in the middle of spin B. It restarts at the textile unfolding region.
4The stocking and the lingerie course omits the unbalance region of 350 rpm.
5The hand cloth/stocking/lingerie course reduces the duration of spin B by one minute. In other courses, reduction is
two minutes.
3) R (Real) spins
1After passing spin B, spin R continues until the entire spin operation is completed.
2Depending on the selected spin operation, the target rpm can be varied.
3During the standard and heavy spin operation, the unbalance value is measured to determine the final target rpm.
4If drying is selected and medium spin is selected, then the strongest spin sequence is performed.
5If acceleration during spins is stopped, the cycle continues at constant rpm and performs braking.
6If you press the pause button during spins, braking will stop the motor.
4) Spins for the sports shoes
1No spin B is performed.
2Like the washing motor operation, it repeats on/off operation with an interval of 10 seconds for five minutes at 45
rpm.
3To remove water, textile pulling is skipped and low temperature drying is done for 36 minutes.
4When the cycle is completed, to clean the tub, one cycle of rinsing and medium spin is used.
5) Hand cloth spins
1Spin B’s duration is one minute.
2The main spin time is 1 minute. The speed changes quickly from 350 rpm to 710rpm.
3Textile pulling is skipped. When the cycle is completed, to clean the tub, one cycle of rinsing and medium spin is
used.
6) Stocking course spins
1Spin B’s duration is one minute.
2Spin B reaches 160 rpm. (350rpm and ascending region omitted.)
3The main spin’s duration is 1 minute and the motor turns at 160 rpm.
4To reduce damage to the stocking, textile pulling is omitted.
7) Lingerie spins
1Spin B’s duration is one minute.
2Spin B reaches 160 rpm. (350rpm and ascending region omitted.)
3The main spin’s duration is two minutes and the motor turns at 200 rpm.
4To reduce damage to the lingerie, textile pulling is omitted.