Service manual

• situation : PCB shows "E3".

cause) ☞FAN MOTOR can not work.

countermeasures) ☞ Replace the Fan Motor.

part name checking results repair method disassemble process of Fan Motor

FAN MOTOR fan motor failure replace

fan motor

1Disassemble Duct Cover As from Duct B As

(Screw 4EA)

2Disassemble FAN AS From Duct Cover As

(Fixed by 8mm NUT)

3Disassemble the FAN MOTOR(SCREW 3EA)

parts Control time

MOTOR 15 sec On, 5sec Off

DRAIN MOTOR Continous working

FAN MOTOR Continous working

DRY HEATER 95°C On, 105°C Off

INLET VALVE 30sec On, 5sec Off

Remarks) control times of each parts during dry process

DUCT COVER AS

Fixed By 8mm NUT