Service manual

12. To remove Rear heater assembly parts.

REF NO. PART CODE PART NAME DESCRIPTION Q’TY REMARK

F01 3511413500 COVER *B SBHG-3 TO.4 1

F02 3511410500 COVER MOTOR *B SA1D-80 T0.5 1

F03 7112401011 SCREW TAPPING T1 TRS 4X10 2

F04 7112401011 SCREW TAPPING T1 TRS 4X10 1

C01 3513002300 HOLDER HEATER SUS304 T0.5 3

C02 3512801800 HEATER 230V 1400W 1R18344 1

C03 3511800700 FAN CONVECTION SA1D-80 T0.5 1

C04 3512806000 HEATER REFLECTOR SA1D T0.5 1

C05 3511409800 COVER HEATER *B SA1D-80 T0.5 1

C06 3513303400 INSULATOR HEATER *B SBHG-1 T0.5 1

C07 3963514330 MOTOR SHADED POLE 230V 50HZ MW10CA-T03 1

C08 7400104011 WASHER PLAIN PW-1-4 MFZN 1

C09 3511800900 FAN PBT 1

C10 7402704600 RING C CR-5 SK5 1

C11 3512781310 HARNESS CONVECTION AS KOC-154K8S 1

C12 7113400814 SCREW TAPPING T1 BIN 4X8 MFNI 1

C13 7001401065 SCREW MACHINE PAN 4X10 BSNI 2

C14 7S627W40X1 SPECIAL SCREW NUT FLANGE M4 1

C15 7113400814 SCREW TAPPING T1 BIN 4X8 MFNI 3

C16 7113400814 SCREW TAPPING T1 BIN 4X8 MFNI 4

C17 7601400811 SCREW MACHINE PAN 4X8 PW 2

1) Remove two screws (F03) and pull out Cover motor *B (F02).

2) Remove a screw (F04) and pull out Cover *B (F01).

3) Remove three screws (C12) (C13) and pull out the harness convection (C11).

4) Remove four screws (C16) and then pull out the Rear heater assembly.

5) Remove the C-Ring (C10) and then pull out the Fan (C09) from Motor shaft.

6) Remove a Nut (C14) and the pull out the Fan convection (C03) and Washer plain (C08).

7) Remove three screws (F15) and pull out the holder heater (C01) and the heater (C02).

9) Remo two screws (C17) and then separate the lnsulator heater *B (C06) and Motor shaded pole (C07).

10)Reverse the above steps for reassembly.