Service manual

19
12. To remove Rear heater assembly parts.
1) Remove a screw 1 and pull out Cover motor *B 2 .
2) Remove a screw
3 and pull out Cover *B 4 .
3) Pull out the Harness convection-B
5 .
4) Remove four screws
t and then pull out the Rear heater assembly.
5) Remove a Nut
q and the pull out the Fan convection 0 and Washer plain 9 .
6) Remove three screws
8 and then separate the Cover heater *B 7 and the lnsulator heater *B r .
7) Pull out two Heaters
6 from the Cover Heater *B 7 .
8) Remo two screw
e and then separate the lnsulator heater *B r and Motor shaded pole y .
9) Remove the C-Ring
i and then pull out the Fan u from Motor shaft.
10)Reverse the above steps for reassebly.
1
2
18
17
16
15
14
13
12
11 10
9
8 7 6
5
3
4
REF NO. PART CODE PART NAME DESCRIPTION Q’TY REMARK
1 7112401011 SCREW TAPPING T1 TRS 4X10 MFZN 1
2 3511407300 COVER MOTOR*B SA1D-80 T0.5 1
3 7112401011 SCREW TAPPING T1 TRS 4X10 MFZN 2
4 3511407900 COVER*B SA1D-80 T0.5 1
5 3512766900 HARNESS CONVECTION-B KOC-1B0K0S 1
6 3512803800 HEATER MIRACLON 115V 550W 270MM 2
7 3511407700 COVER HEATER*B SA1D-80 T0.5 1
8 7113400814 SCREW TAPPING T1 BIN 4X8 MFNI 3
9 7400504211 WASHER PLAIN PW5-5 BRASS 1
10 3511800700 FAN CONVECTION SA1D-80 T0.5 1
11 7391400065 NUT HEX 6N-1-4 BSNI 1
12 3512766800 HARNESS CONVECTION-A KOC-1B0K0S 1
13 7051400811 SCREW MACHINE PAN 4X8 SW MFZN 2
14 3513302900 INSULATOR HEATER*B SBHG-1 T0.5 1
15 7113400814 SCREW TAPPING T1 BIN 4X8 MFNI 4
16 3963514300 MOTOR SHADED POLE 230V 50HZ MW10CA-TO 1
17 3511800800 FAN PP GF20 1
18 7402704600 C-RING CR-5 SK5 1
✔ Caution: In this Service Manual, some parts can be changed for improving, their performance without notice in the parts list. So, if you need the
latest parts information, please refer to PPL(Parts Price List) in Service information Center(http://svc.dwe.co.kr)