Service manual

11
4. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part ‘A’
Loosen two screws on the stopper hinge top, and
then push the door to contact the door seal to the
oven front surface.
• Tighten two screws.
(2) To reduce gap located on part ‘B’
Loosen two screws on the stopper hinge under, and
then push the door to contact the door seal to the
oven front surface.
• Tighten two screws.
(3) To reduce gap located on part ‘C’
Loosen the screw on the interlock switch assembly
located the top of the oven body.
Draw the interlock switch assembly inward as possible
to engage with the hook on the door bottom.
• Tighten a screw.
(4) To reduce gap located on part ‘D’
Loosen the screw on the interlock switch assembly
located the bottom of the oven body.
NOTE : A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm
2
.