Contents 1. 2. SAFETY WARNINGS.................................................................................................... 1 INSTALLATION........................................................................................................... 1 2.1 2.2 Reversing the Door Swing ................................................................................... 2 2.4 Levelling the Unit................................................................................................ 4 2.3 2.
1) WARNING Do not use mecha nical devices or ot her means to accelerate the defros ng process, other than those recommended by the manufacturer. 2) WARNING 3) WARNING Do not damage the refrigerant circuit. Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer. 4) WARNING DANGER: Risk of child entrapment.
2.1 Location When selec ng a posi on for your unit you should make sure the f loor is flat and rm, and the room is well ven lated. Avoid loca ng your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it may increase the electrical consump on. Extreme cold ambient temperatures may also cause the unit not to perform properly. This unit is not designed for use in a garage or outdoor installa on. Do not drape the unit with any covering.
4) Remove the plas c cover from door hinge rst. Then unscrew the two screws from top bracket and replace on the other side. 5) To install the bracket on the le side of the appliance, screw the two screws through the bracket and into the top of the appliance. Slide the door back on to the top hinge. Ensure the door is face up. Replace the plas c cover on the top bracket by pressing down un l it clicks into posi on. 6) Screw the bo om hinge into place on the new side. Replace the foot on the other side.
2.4 Levelling the Unit To do this adjust the two levelling feet at the front of the unit. If the unit is not level, the door and magne c seal alignments will not be covered properly. 2.5 Cleaning Before Use Wipe the inside of the unit with a weak solu on of bicarbonate soda. Then rinse with warm water using a 'Wrung-out' sponge or cloth. Wash the shelves and salad bin in warm soapy water and dry completely before replacing in the unit. Clean the exterior of the unit with a damp cloth.
Chiller compartment door Wire steel bar Drip tray Steel wire shelf Adjustable leveling leg *Al l i mages in this instruc on manuala re for indica on only; please refer to your i ndividual unit for details. 4.
but you should be aware of them! These noises are caused by the circula on of the refrigerant liquid in the cooling system. It has become more pronounced since the introduc on of CFC free gases. This is not a fault and will not affect the performance of your unit. This is the compressor motor working, as it pumps the refrigerant around the system. 4.3 Tips for Keeping Food in the Unit Cooked meats/fishes should always be stored on a shelf above raw meats/fishes to avoid bacterial transfer.
temperature. Wipe of any moisture residue. If the problem con nues, please contact a qualif ied technician for assistance. 6.1 Care When Handling/Moving Your Unit Hold the unit around its sides or base when moving it. Under no circumstances should it be li ed by holding the edges of the top surface. Avoid damaging the refrigerant tubing when handling, moving and use of refrigerator. 6.2 Servicing The unit should be serviced by an authorized engineer and only genuine spare parts should be used.
7.1 Warm tips: The refrigerator enclosure may emit heat during opera on specially in summer, this is caused by the radia on of the condenser, and it is a normal phenomenon. Condensa on: condensa on phenomenon will be detected on the exterior surface and door seals of the freezer when the ambient humidity is large, this is a normal phenomenon, and the condensa on can be wiped away with a dry towel. Buzz: Buzz will be generated by running compressor specially when star ng up or shu ng down.
