Operation Manual

43
CLEANING DUST CONTAINER PRECAUTIONS FOR SAFE USE
This vacuum cleaner should only be used for normal dry household dust and dirt.
The manufacturer cannot be responsible for any damage caused by use or operation of the
cleaner contrary to these instructions.
If the cleaner is wrongly operated for a purpose other than that for which it is intended. no
liability can be accepted for any possible damage.
REPLACING PARTS
• Switch off. • Press the lock of outlet rear
board, and dismantle the outlet
rear board, then take out the
outlet filter to clean or replace it.
• Separate the filter from the filter
case and shake the dust out of
the filter.
• Do not vacuum areas which contain moisture
or water and inflammable matter, needles,
pins, razor blades, matches, cigarette-ends,
etc., since they may damage the cleaner or
dust bag or cause a fire.
• When rewinding the power cord, hold the plug
body before pressing the cord rewind button
to prevent whipping.
• Do not pull the power cord beyond the
specified length.
• Make sure a dust bag and a motor protection
filter are always inserted.
• This product provided with a cable which, if
damaged must be replaced by a repair shop
authorized by the manufacturer since special
tools are required.
• Press the lock on the front cover
and open it.
• Take out the container upwards. • Press the under lock of the container,
the under cover of the container will
open automatically. then the dust will
pour out and clean up the dust
container immediately.
EXHAUST FILTER
MOTOR PROTECTION
FILTER
• Press the lock on the front cover
and open it.
• Take out the container upwards. • Check if the HEPA filter is
clogged. if so, open the top
cover of dustcup before you take
out the HEPA cover. Then take
the HEPA out to cover clean it
up and then assemble it.