Biologic ™ ReeCharge Owner’s Manual
Biologic ™ ReeCharge CAUTION Carrying the ReeCharge The ReeCharge contains delicate components. Do not bend, drop, or crush ReeCharge units. Using connector ports Never force a connector into a port. Make sure that the connector matches the port and that you have positioned the connector correctly in relation to the port. Keep the ReeCharge within acceptable temperatures Battery life might be affected by extreme temperature conditions. Always keep the ReeCharge between -20°C and 45°C.
The ReeCharge can be charged using a USB port. When charging the ReeCharge with alternative power sources, use only 5V DC output charging devices rated at less than 1A. The ReeCharge and its adaptor may become warm during normal use. Always allow adequate ventilation around the ReeCharge. Please read the safety instructions for all products and accessories before using them with the ReeCharge.
Choking hazard The ReeCharge contains small parts, which may present a choking hazard to small children. Keep the ReeCharge and its accessories away from small children. Do not throw in trash The built-in lithium-ion battery can be recycled. Please dispose of the battery at the nearest recycling location in your area. Notice Dahon and MINIWIZ are not responsible for any failures the ReeCharge might cause to devices charged with the unit.
FEATURES 1. The ReeCharge enables the charging of a mobile device from a bicycle dynamo hub. 3. The ReeCharge can be securely fastened onto a bicycle handlepost, stem or handlebar, so that it can be charged while cycling. 4. E lectronic devices can be charged through the ReeCharge while cycling or they can be charged from the charged battery of the ReeCharge when not cycling. 5.
ReeCharge Overview 1 7 2 3 4 5 6 8 9 1. Charge In Button 2. Battery Status Button 3. Charge Out Button 4. Charging Indicator Lights 5. Charging Socket 6. Charge Out USB Socket 7. Battery Status/ Safety Light 8. Self Opening Sealing Flaps 9. USB charging cable (included). 1. Charge In Button • Push this button to start or stop charging the ReeCharge. • The ReeCharge is being charged when the green light on the side of the device is lit.
3. Charge Out Button • Push this button to start or stop charging external devices through the ReeCharge. • The ReeCharge is charging any attached device when the red light on the side of the ReeCharge is lit. • NOTE: When the red light on the side of the ReeCharge is lit the ReeCharge is releasing its charge no matter if a device is connected or not. • Make sure that the red light is off if you do not intend to charge other devices or do not want the ReeCharge to discard completely. 4.
7. Battery Status/ Safety Light • Shows the ReeCharger’s battery status -- 3 lights lit: Fully charged (over 80%) -- 2 lights lit: Half full -- 1 light lit: Almost empty -- No lights lit: Empty • The lights also serve as a safety light at night. 8. Self Opening Sealing Flaps • The ReeCharge has water sealing flaps in front of the cable connecting ports. These flaps open inwards when pushing the cable into the socket. • Just push the plugs into the ports and the flaps will open. 9.
1 2 3 4 5 6 Included set of connector adapters 1. Apple Connector 2. Sony Ericsson 3. Samsung 4. Later-model Nokia 5. Motorola/ Mini USB 6. USB Charging Cable Connector Adapter N OTE: Though this connector will fit early model Nokia phones, it will NOT allow the ReeCharge to charge them. NOTE: To charge Apple products with the ReeCharge, you need to use the Apple Connecting with the USB cable that was included with the Apple device.
Charging the ReeCharge The ReeCharge can be charged in three different ways: A. From a bicycle dynamo hub B. From a PC / laptop USB 2.0 port C. From a conventional 100~240V AC wall adaptor (Not included with OEM package. Only included in aftermarket package) A. Charging from a bicycle dynamo hub 1. Fasten the ReeCharge to the bike (see Mounting the ReeCharge). 2. Connect the ReeCharge to the dynamo hub with the power regulator cable (see Connecting the ReeCharge to the Dynamo Hub). 3.
ReeCharge Dynamo Hub (not included) Power Regulator & Cable To starting charging the ReeCharge, press the Charge In Button. This enables the device to be charged. NOTE: If charging is not enabled with the Charge In Button the ReeCharge will not charge, even when the bike is in motion. he ReeCharge itself is T charging when the green light on the side of the device is lit. NOTE: The green light is only lit when the wheel rotates fast enough to charge the ReeCharge.
B. Charging from a PC / laptop USB 2.0 port ReeCharge USB Charging Cable Connector Adapter Retractable USB Charging Cable 1. F asten the retractable USB charging cable to the PC´s USB port. 2. F asten the other end of the USB cable to the USB charging cable connector adapter. 3. C onnect the adapter to the Charging Socket of the ReeCharge. 4. P ress the Charge In Button to enable charging. 5. The ReeCharge is charging when the green light on the side of the ReeCharge is lit.
C. C harging from a conventional 100~240V AC power converter (NOTE: AC power converter kit available only in after market package) Electric Outlet Power Converter Power Converter Release Button North America Adapter EU Adapter 1. Select the wall plug adapter to the match the available electric network. The ReeCharge is equipped with adapters for EU and North America. 2. C onnect the proper wall plug adapter to the power converter.
5. P ress the Charge In Button to enable charging. 6. The ReeCharge is charging when the green light on the side of the ReeCharge is lit. NOTE: If the green light on the side is not lit the ReeCharge is not charging even if the cable is connected to the electic outlet.
Charging external devices with the ReeCharge The ReeCharge’s internal battery needs to have some charge before it can charge other devices. Other devices can be charged at the same time when the ReeCharge is charging or they can be charged after the battery of the ReeCharge is first charged. Depending on the device being charged there are two different situations when charging with the ReeCharge. • S ituation 1: Charging most electronic devices with the ReeCharge.
Situation 1: Charging most external devices with the ReeCharge Adapter Plug* *NOTE: Different adapter plugs are used with different devices. 1. Connect the retractable USB charging cable to the Charge Out USB socket of the ReeCharge. 2. Connect the other end of the retractable USB charging cable to the appropriate adapter plug. NOTE: Different adapters allow the charging of different devices. For a list of devices that can be charged, please see: USB Adaptor Support List. 3.
Situation 2: Charging electronic devices from Apple with the ReeCharge Apple Connector* iPhone/ iPod Dock Connector cable (not included with ReeCharge) *The ReeCharge cannot charge Apple products without the use of this connector. 1. Connect the Apple Connector to the Charge Out USB socket of the ReeCharge. 2. Connect the Dock Connector to USB Cable (not included) to the Apple Connector. 3. Connect the other end of the USB cable to the iPhone/ iPod. 4.
NOTE: The charging of Apple products requires the use of the Apple Connector. Without this connector, the device will not charge. The ReeCharge cable cannot be used to charge Apple products. NOTE: When the red light on the side of the ReeCharge is lit, the ReeCharge is discharging even if a device is not connected to it.
Mounting the ReeCharge If the ReeCharge came with your Dahon bike, it is already completely mounted and installed on your bike. Please refer to the following instructions if you bought the ReeCharge separately or if for some reason the ReeCharge was removed from your bike and you want to remount it. WARNING: If you are in any way unsure of how to perform this assembly, take your bike to a qualified bicycle technician for professional assembly.
Connecting the ReeCharge to the dynamo hub together with a front light The ReeCharge can be connected to a dynamo hub that already has a light unit connected to it. The ReeCharge can also be connected to dynamo hub without the light cable. NOTE: When using the light and charging the ReeCharge simultaneously, the power from the dynamo hub is split between the two devices, which might lower the brightness of the light, which can compromise safety in darkness.
2. R emove the cover of the cable connector. 3. Pull out the wires from the grey wire holder. 4. Twist the ends of the ReeCharge cable with that of the light cable. 5. P ut the connected light and ReeCharge wires back into the grey wire holder. 6. F ix the wires into the grey wire holder by bending them around the holder. 7. P ut the black cover back onto the grey wire holder. 8. Attach the cable connector to the dynamo hub.
Power Regulator Cable 9. F asten the power regulator with zipties to the front fork. Connect the cable to the fork so that it does not go between the spokes when cycling. 10. Connect the free end of the ReeCharge cable to the Charge In Socket of the ReeCharge.
Fastening external devices to the bicycle handlebar A wide selection of different devices can be mounted on the bike handlebar with a silicon fastening strap (Not included with the bicycle. Only available in aftermarket packaging). 1 2 3 4 NOTE: Cycling can cause strong shaking of the handlebar, which might make any attached device fall out of the elastic fastening strap causing serious damaged to the device. Dahon and MINIWIZ are not liable for any damages caused by the failure of this fastening strap.
Technical Specifications Size: • Height: 85 mm/ 3.3 inches • Width: 60 mm/ 2.4 inches • Depth: 30 mm/ 1.2 inches • Weight: 3 ounces (~90 g) Battery: Built-in 1600mAh lithium-ion polymer rechargeable battery Input current: less than 1A or 1000mA and 5V max Minimum operating speed: 15 km/h (based on a 20” wheel with 6V/ 2.4W dynamo hub) Type of power inputs: • Bicycle dynamo hub (input voltage and current varies with different cycling speed and battery loading conditions) • PC/ laptop USB 2.
USB adapter support list* * V alid as of September 1, 2009. For models not listed below, consult with your device manufacturer. Compatible with: Apple3 iPhone 2G/3G/3Gs, iPod touch, iPod nano, iPod 5th generation, iPod classic, iPod video Most new Nokia4, Sony Ericsson5, Motorola7, BlackBerry8, iRiver10, Garmin9 GPS, TomTom11 and new Samsung6 phones and devices Some Digital Cameras and many other devices that can be charged via a USB Port. Referenced Trademarks 1.
7. Motorola is a registered trademark of Motorola, Inc in the U.S.A. or other countries.. 8. BlackBerry® is a registered trademark of Research In Motion in Canada or other countries. 9. Garmin® is a registered trademark of Garmin Ltd. in the U.S.A. or other countries. 10. iriver is a registered trademark of ReignCom Co., Ltd. in the U.S.A.or other countries. 11. TomTom® is registered Trademark of TomTom International. * Brand and product names mentioned are trademarks of their respective companies.
*M INIWIZ and Dahon accept no responsibility for damages of other devices charged by the BioLogic™ ReeCharge. Dahon California INC. 833 Meridian Street Duarte CA 91010 1-800-442-3511 Dahon TW 8F-8, #6, Lane 609, Chung Hsin RD., Sec 5 San Chung, Taipei Hsien ROC 241, Taiwan +886-2-2999-5623 http://www.thinkbiologic.