Operation Manual


It is to configure the rule of intrusion.
1. Click , double click the new rule, set rule name, and select rule type as "Intrusion", which is shown
in Figure 4-66.

Figure 4-66
2. Click "Draw Rule" to draw rules on the monitoring image, right click to end drawing;
Note
 It takes some time and space from when the target appears to when the target is confirmed,
therefore, it has to leave some space when drawing the warning area, don't draw rules near the
blocking object.
 Click "Clear" to delete all the drawn monitoring areas.
3. Select max size or min size, click "Draw Target", and drag any angle of the filter box to enlarge or
narrow the filter box to proper size.
Note
 It will alarm only when the size of target is between two filter boxes.