Operation Manual


4.4.10 Abnormity
Abnormity includes SD card abnormity, network abnormity and illegal access.
Note
Only the device with SD card function has these three statuses: No SD card, Capacity warning, and SD
card error.
4.4.10.1 SD Card Abnormity
The system can generate alarm and activate the actions which have been set when SD card is
abnormal. SD card abnormity includes No SD card, capacity warning and SD card error.
Step 1
Select “Setup > Event > Abnormity > SD Card" and the system will display the interface of “SD Card”,
which is shown in Figure 4-81
Figure 4-81
Step 2
It is to set event type.
Step 3
Select "Enable" to enable the function of SD card abnormity detection.
Step 4
It is to set the parameters of SD card abnormity detection, please refer to Table 4-42 for more details.
Parameter
Function
Capacity Limit
It can set the parameter when the "Event Type" is set as "Capacity
Warning".
It is to set the percentage of SD card remaining capacity, it will generate
alarm when the remaining capacity is less than the percentage.