Specifications

Telit GM862-PCS/-GPRS/-GSM Product Description

1vv0300604, Rev. ISSUE#14 - 22/01/04

6.4.3.5 A/ - Last command automatic repetition

A/ – last command automatic repetition

Execute command

A/ It is used to execute again the last received command.

This command works only at fixed IPR.

Note: This command has been substituted with AT#/ command.

Refer to #/ command reference.

Read command

Write command

Test command

Example

Reference

SW release Version A

6.4.3.6 H - disconnect

H - disconnect

Execute command

ATH It is used to close the current conversation (voice, data or fax).

Note: When a data conversation is active the device is in on-line mode

commands are not sensed, instead characters are sent to the other

interlocutor. To issue this command you must be in command mode

operation, hence escape sequence (see register S2) may be required before

issuing this command, otherwise if &D1 option is active, DTR pin should be

tied low to return in the command mode.

When a voice call is active, no escape sequence is needed.

Read command

Write command

Test command

Example

Reference V25ter.

SW release Version A