Use and Care Manual

DAICH Textured Primer is a high-performance multi-purpose primer for water-based concrete fl oor
paints. It imparts excellent adhesion to prepared surfaces, as well as slip-resistant texture that
transmits through most paint top-coats for added foot traction.
Used as part of a DAICH decorative concrete fi nish system, Textured Primer penetrates and locks
rmly onto concrete and more, while creating an ideal bonding base for any of the DAICH decorative
stone concrete coatings. It masks blotchy color and repairs — and also acts as the visible “grout
joint” in patterned tile and stone designs using DAICH Concrete Stencils or Grout Line Pattern Tape.
It’s also breathable, which encourages the escape of moisture vapor through the coating to assist in
avoiding trapped moisture in the slab. It delivers resilient hold through the seasons and helps your
new concrete surface transformation last for years.
PERFORMANCE FEATURES
INTERIOR • EXTERIOR
DAICH Textured Primer penetrates and locks firmly onto concrete and more to create an ideal bonding
base for any of the DAICH decorative stone concrete coatings. It masks underlying blotchy color and
repairs in the surface — and also acts as the visible “grout joint” in patterned tile and stone designs
using DAICH Concrete Stencils or Grout Line Pattern Tape.
If you are using it as part of your DAICH SpreadStone™, Terrazzo,™ RollerRock® or SpreadRock®
finish, just roll one uniform coat and proceed as directed.
SURFACE PREPARATION:
For optimal long–term performance, surface should be clean and dry – and free from dust, dirt, spalling, efflorescence,
oil, poorly bonded or glossy paint, glue, surface sealers and other contaminates. New concrete – minimum 28 day
cure before application. New masonry – 48 - 72 hours cure before coating.
CONCRETE / MASONRY / BRICK:
1) Surface should be level and in good condition. Chip away any loose or flaking concrete and skim coat any rough
or uneven areas with a quality levelling compound. Allow to cure as directed. 2) If concrete is smooth, new or
efflorescent, the surface must be etched using Daich Concrete Cleaner/Etcher as directed, or a two-parts water / one-
part muriatic acid solution (consult muriatic acid container for mixing and safety instructions). For very smooth concrete,
etching twice is advisable. If concrete is heavily soiled, cleaning may be required prior to etching to ensure best results.
After etching, follow with general cleaning. 3) Whenever possible, clean concrete with a pressure washer. (For
best results, especially for exterior surfaces, a minimum of 2000 psi is recommended in a slow sweeping motion. Hold
spray fan tip 4” above the concrete to effectively clean out pores for best bond.) If a pressure washer is not available,
scrub the surface with Daich Concrete Cleaner/Etcher or a strong TSP solution. Rinse thoroughly, removing all
washing/etching debris with clean water and a scrub broom followed by thorough rinse.
Mixing: Daich Textured Primer is pre-mixed and ready to
apply. Stir before use.
APPLICATION
1) Application temperature range - 50ºF - 80ºF. 2) Apply by
paint roller until the surface is thoroughly and uniformly
coated. 3) Brush or roll carefully into all surface texture, light
pitting, etc. for full contact over the entire surface. Coated
surface must be uniformly covered without show-through.
4) For broom finished concrete, brush uniformly into and
in the same direction as the broom texture for full contact.
Let dry 20-30 minutes and follow with a roller-applied coat
(same direction as the broom texture) to fill the broom texture
completely. 5) Two coats are recommended for projects
utilizing a DAICH decorative stencil or grout line effect.
APPLICATION TOOLS: Use a 3/8” roller for level unpitted
concrete. For textured surfaces, use a 1/2” pile roller for better
penetration. Paint brush for edges and deeper texture.
DRY & CURE TIMES: Outdoor dry (>70º F) 30 - 60 minutes
(longer in damp or cool conditions). Indoor dry (>70º F) 1 - 2
hours (due to limited air flow). Full cure: 24 hours.
COVERAGE: Average of 160 sq.ft. (15m2) per gallon (18.9
liters) based on one uniform coat over a smooth surface.
Varies with roughness of surface and application technique.
STORAGE: Textured Primer may be stored in its original
unopened container in a cool dry place for up to two years.
PRECAUTIONS:
Avoid contact with eyes and skin, flood eyes repeatedly with
potable water for 15 minutes. DO NOT RUB EYES due
to course nature of material. Wash hands thoroughly after
handling. Do not take internally. KEEP OUT OF REACH OF
CHILDREN. Keep container closed. Dispose of old material
as prescribed by local laws.
HAMILTON, ON • MADE IN CANADA
Textured Primer - Raw Gray
DCPR-378-RG
LOCKS ONTO CONCRETE, MASONRY AND MORE
Optimal Bonding Surface For All Daich Stone Floor Finishes
VOC: Less than 50 grams/liter
1 GALLON
(3.78L)
• roller or brush applied
• freeze/thaw resistance
• UV resistant
• breathability
• low shrinkage / fl exible
• excellent adhesion
• visible colored grout effects
• abrasion/impact resistant
• easy maintenance
• crack resistant
• colorfast
• water-based, low VOC
DESCRIPTION:
Pre-mixed, non-cementitious stone matrix coating for interior/exterior fl oor and wall surfaces.
USES:
An optional additional layer of strength and performance that can be applied prior to any of the DAICH
self-priming decorative stone coatings. Also acts as the visible colored grout effect in decorative tile
and fl agstone projects.
Used on stationary EXTERIOR concrete, masonry, prepared tile, styrofoam
and wall board. INTERIOR applications on concrete, masonry, drywall, tile, vinyl, linoleum and
laminates.
PACKAGING: Textured Primer is available in: 1 gallon (3.78 liter) and 5 gallon (18.9 liter) containers.
COVERAGE: Up to 160 sq.ft. (15 m
2
) per gallon. Varies with substrate texture and application thickness.
COLOR SELECTION: Textured Primer is available in fi ve standard factory-tinted colors to let you choose
just the right grout color and contrast in your tile or fl agstone project for maximum decorative
appeal. Alternatively, if you just want an optional added layer of strength and performance beneath your
seamless Daich coating project, choose a color that is most similar to your chosen stone fi nish.
www.daichcoatings.com • 1-866-GO-DAICH (463-2424)
Raw Gray Bone Dolphin Charcoal Antique Gold

Summary of content (2 pages)