Installation Guide

www.daichcoatings.com • 1-866-GO-DAICH (463-2424)
SEALING:
Once fully cured for at least 24 hours (longer in damp or cool conditions that lengthen dry time), SpreadRock finishes must be sealed
with DAICH Ultra Clear Coat Sealer or, for automotive surfaces, DAICH DaiHard Garage & Driveway Sealer. These sealers are
an important final part of the SpreadRock resurfacing system. They optimize overall water-resistance, cleanliness and long-term
durability. Apply two coats 4 - 6 hours apart. Wear clean shoes to keep Spreadrock clean before sealing. Re-seal every 2 - 3 years
for residential surfaces and 1 - 2 years for higher traffic commercial areas and public spaces.
**For ultimate cleanliness and protection from oil, grease and chemicals — and a beautiful showroom finish, seal garage floors,
basements, etc. with a thin uniform coat of DAICH DaiHard 100 Epoxy Clear Coat.
For more information, visit www.daichcoatings.com.
CLEAN UP:
Equipment can be cleaned with soap and water prior to cure of material.
MAINTENANCE:
Most stains from food or beverages can be easily cleaned using water or any effective multi-purpose or citrus cleaner, and a
sponge or deck brush. For the most stubborn stains, we suggest X-Mess Multi-Purpose Cleaner by DAICH COATINGS for easy safe
cleaning of Daich Textured finishes and most other surfaces.
PRECAUTIONS:
In case of contact with eyes, flood eyes repeatedly with potable water and call a physician. DO NOT RUB EYES due to granular
nature of material. Wash hands thoroughly after handling. Do not take internally. KEEP OUT OF REACH OF CHILDREN. Keep
container closed. Do not use in the presence of unprotected foodstuffs. Keep product from freezing. Product which has been frozen
must be discarded. Dispose of unused material in accordance with local, provincial and federal guidelines.
CURE TIME:
Dry to touch in 60 minutes, depending on atmospheric conditions. Protect coated surfaces for 6-8 hours prior to exposure to rain or
heavy condensation. Avoid foot traffic until the following day. In dry conditions product cure is complete in 24 hours.