Operation Manual

English

Cleaning the air lter

(If is displayed on the remote controller)

1. Open the front panel.

• Open the front panel by placing a nger on the panel tab on either side of the front panel and then secure it using the

supporting plate on the right.

Supporting

plate

2. Pull out the air lters.

Air filter

• Push a little upwards the air lter. • Pull the air lter down.

3. Clean the air lter.

• Wash the air lters with water or clean them with vacuum cleaner.

• If the dust does not come off easily, wash them with neutral detergent thinned with lukewarm water,

then dry them up in the shade.

4. Set the air lter as it was and close the front panel.

• Insert the air lter with the “FRONT” marking to the

front.

• Be sure to insert the two tabs below.

• Return the supporting plate to its previous position.

• Press either side of the front panel.

5. Reset the lter cleaning

indicator.

Page 20

Tabs

NOTE

• Using without cleaning will lower the COOLING or HEATING capability, wasting electricity.

01_EN_3P226009-1A.indd 23 10/29/2012 2:12:08 PM