Service Manual

FFQ Series SiUS121502E
96 Remote Controller
4.3 <BRC7E830> Wireless Remote Controller
(R18863)
8
10
13
11
12
15
14
16
17
9
1
3
4
6
2
5
7
21
20 22
23
19
18
(R17873)
1
2
3
DISPLAY (SET TEMPERATURE)
This display shows the set temperature.
4
5
DISPLAY (AIRFLOW FLAP)
6
DISPLAY (FAN SPEED)
The display shows the set fan speed.
7
8
ON/OFF BUTTON
9
FAN BUTTON
10
TEMPERATURE SETTING BUTTON
11
PROGRAMMING TIMER BUTTON
12
TIMER MODE START/STOP BUTTON
13
TIMER RESERVE/CANCEL BUTTON
14
SWING BUTTON
15
OPERATION MODE SELECTOR BUTTON
16 FILTER SIGN RESET BUTTON
17
INSPECTION/TEST BUTTON
18
EMERGENCY OPERATION SWITCH
19
RECEIVER
20
OPERATING INDICATOR LAMP (Red)
21
TIMER INDICATOR LAMP (Green)
This lamp stays lit while the timer is set.
22
23
DEFROST LAMP (Orange)
DISPLAY (SIGNAL TRANSMISSION)
This lights up when a signal is being
transmitted.
DISPLAY , , , ,
(OPERATION MODE)
This display shows the current operation
mode.
DISPLAY (PROGRAMMED
TIME)
This display shows programmed time of
the system start or stop.
DISPLAY (INSPECTION/ TEST
OPERATION)
When the INSPECTION/TEST button is
pressed, the display shows the system
mode is in.
Press the button and the system will start.
Press the button again and the system will
stop.
Press this button to select the fan speed,
HIGH or LOW, of your choice.
Use this button for setting temperature
(Operates with the front cover of the
remote controller closed.)
Use this button for programming start and/or
stop time. (Operates with the front cover of
the remote controller opened.)
Press this button to select operation mode.
This button is used only by qualified service
persons for maintenance purposes.
This switch is readily used if the remote
controller does not work.
This receives the signals from the remote
controller.
This lamp stays lit while the air conditioner
runs. It flashes when the unit is in trouble.
AIR FILTER CLEANING TIME INDICATOR
LAMP (Red)
Lights up when it is time to clean the air
filter.
Lights up when the defrosting operation has
started.