Operation Manual

19
Care
 Titanium apatite photocatalytic air-purifying lter
1. Open the front panel and
pull out the air lters.
Page 18
2. Take off the titanium apatite
photocatalytic air-purifying
lters.
• Remove the lters from the tabs.
3. Clean or replace the
titanium apatite
photocatalytic air-purifying
lters.
[Cleaning]
3-1 Vacuum dust, and soak in lukewarm
water or water for about 10 to
15 minutes if very dirty.
• Do not remove the lter from the frame when
washing with water.
3-2 After washing, shake off remaining
water and let them dry in the shade.
• Do not wring out the lter to remove water from it.
[Replacement]
Remove the lter from the tabs
and prepare a new one.
• Dispose of the old lter as non-ammable waste.
4. Insert the titanium apatite
photocatalytic air-purifying
lters as they were.
• When attaching the lter, check that the lter is
properly set in the tabs.
5. Reattach the lters.
Page 18
6. Close the front panel
slowly.
Page 18
NOTE
• Operation with dirty lters:
− cannot deodorize the air,
− cannot clean the air,
− results in poor heating or cooling,
− may cause odor.
• Dispose of old lters as non-ammable waste.
• To order a titanium apatite photocatalytic air-purifying lter, contact
the dealer where you bought the air conditioner.
Item
Titanium apatite photocatalytic
air-purifying lter 1 set
Part No. KAF970A46
Care and Cleaning