3PEN291652-2D.
PEN291652-2D.book Page 1 Monday, June 8, 2015 2:40 PM CONTENTS READ BEFORE OPERATION Safety precautions ........................................ 2 Names of parts .............................................. 4 Preparation Before Operation ....................... 7 OPERATION AUTO · DRY · COOL · HEAT · FAN Operation .................................................... 10 Adjusting the Airflow Direction .................... 12 POWERFUL Operation ............................... 14 ECONO Operation ..........
3PEN291652-2D.book Page 2 Monday, June 8, 2015 2:40 PM READ BEFORE OPERATION Safety precautions • • • • Keep this manual where the operator can easily find it. Read this manual attentively before starting up the unit. For safety reason the operator must read the following cautions carefully. This manual classifies precautions into WARNING and CAUTION. Be sure to follow all precautions below: they are all important for ensuring safety.
3PEN291652-2D.book Page 3 Monday, June 8, 2015 2:40 PM • Do not block air inlets nor outlets. Impaired air flow may result in insufficient performance or trouble. • Do not stand or sit on the outdoor unit. Do not place any object on the unit to avoid injury, do not remove the fan guard. • Do not place anything under the indoor or outdoor unit that must be kept away from moisture. In certain conditions, moisture in the air may condense and drip.
3PEN291652-2D.
3PEN291652-2D.book Page 5 Monday, June 8, 2015 2:40 PM Outdoor Unit 15 17 16 19 18 Indoor Unit 1. Air filter 2. Titanium Apatite Photocatalytic Air-Purifying Filter: • These filters are attached to the inside of the air filters. 11. Indoor Unit ON/OFF switch: (page 10.) • Push this switch once to start operation. Push once again to stop it. • The operation mode refers to the following table. 3. Air inlet Mode 4. Front panel AUTO 5. Panel tab 6.
3PEN291652-2D.book Page 6 Monday, June 8, 2015 2:40 PM Remote Controller 1 R 2 3 4 7 11 ECONO POWERFUL TEMP MODE FAN COMFORT ON OFF 5 ON/OFF 6 SWING 8 9 CANCEL 10 14 TIMER 16 15 13 12 R 1. Signal transmitter: • It sends signals to the indoor unit. 2. Display: • It displays the current settings. (In this illustration, each section is shown with all its displays ON for the purpose of explanation.) 3. ECONO button: ECONO operation (page 15.) 4.
3PEN291652-2D.book Page 7 Monday, June 8, 2015 2:40 PM Preparation Before Operation To set the batteries 1. Slide the front cover to take it off. Position + and – correctly! 2 2. Set two dry batteries AAA.LR03 (alkaline). – + + – 3. Set the front cover as before. 3 1 ATTENTION About batteries • When replacing the batteries, use batteries of the same type, and replace the two old batteries together. • When the system is not used for a long time, take the batteries out.
3PEN291652-2D.book Page 8 Monday, June 8, 2015 2:40 PM Preparation Before Operation To operate the remote controller • To use the remote controller, aim the transmitter at the indoor unit. If there is anything to block signals between the unit and the remote controller, such as a curtain, the unit will not operate. • Do not drop the remote controller. Do not get it wet. • The maximum distance for communication is about 7m. R Receiver To fix the remote controller holder on the wall 1.
3PEN291652-2D.book Page 9 Monday, June 8, 2015 2:40 PM To set the clock R 1. Press “CLOCK button”. is displayed. blinks. 2. Press “TIMER setting button” to set the clock to the present time. ECONO Holding down “ ” or “ ” button rapidly increases or decreases the time display. POWERFUL TEMP MODE FAN COMFORT ON/OFF 3. Press “CLOCK button”. blinks. Turn the breaker ON ON • Turning ON the breaker opens the flap, then closes it again. (This is a normal procedure.
3PEN291652-2D.book Page 10 Monday, June 8, 2015 2:40 PM OPERATION AUTO · DRY · COOL · HEAT · FAN Operation The air conditioner operates with the operation mode of your choice. From the next time on, the air conditioner will operate with the same operation mode. R To start operation 1. Press “MODE selector button” and select an operation mode. • Each pressing of the button advances the mode setting in sequence.
3PEN291652-2D.book Page 11 Monday, June 8, 2015 2:40 PM To change the airflow rate setting 5. Press “FAN setting button”. DRY mode AUTO or COOL or HEAT or FAN mode Five levels of airflow rate setting from “ The airflow rate setting is not variable. plus “ ”“ ” to “ ” ” are available. • Indoor unit quiet operation When the airflow is set to “ ”, the noise from the indoor unit will become quieter. Use this when making the noise quieter.
3PEN291652-2D.book Page 12 Monday, June 8, 2015 2:40 PM Adjusting the Airflow Direction You can adjust the airflow direction to increase your comfort. R To adjust the horizontal blade (flap) 1. Press “SWING button”. • “ ” is displayed on the LCD and the flap will begin to swing. 2. When the flap has reached the desired position, press “SWING button” once more. • The flap will stop moving. • “ ” disappears from the LCD.
3PEN291652-2D.book Page 13 Monday, June 8, 2015 2:40 PM To start COMFORT AIRFLOW operation 3. Press “COMFORT AIRFLOW button”. • The position of the flap will change, preventing air from blowing directly on the occupants of the room. • “ ” is displayed on the LCD. • Airflow rate is set to “AUTO”. COOL/DRY The flap will go up. HEAT The flap will go down. To cancel COMFORT AIRFLOW operation 4. Press “COMFORT AIRFLOW button” again.
3PEN291652-2D.book Page 14 Monday, June 8, 2015 2:40 PM POWERFUL Operation POWERFUL operation quickly maximizes the cooling (heating) effect in any operation mode. You can get the maximum capacity. R To start POWERFUL operation 1. Press “POWERFUL button”. • POWERFUL operation ends in 20 minutes. Then the system automatically operates again with the previous settings which were used before POWERFUL operation. • “ ” is displayed on the LCD.
3PEN291652-2D.book Page 15 Monday, June 8, 2015 2:40 PM ECONO Operation ECONO operation is a function which enables efficient operation by lowering the maximum power consumption value. To start ECONO operation R 1. Press “ECONO button”. • “ ” is displayed on the LCD. To cancel ECONO operation 2. Press “ECONO button” again. • “ ” disappears from the LCD.
3PEN291652-2D.book Page 16 Monday, June 8, 2015 2:40 PM TIMER Operation Timer functions are useful for automatically switching the air conditioner on or off at night or in the morning. You can also use OFF TIMER and ON TIMER in combination. R To use OFF TIMER operation • Check that the clock is correct. If not, set the clock to the present time. (page 9.) 1. Press “OFF TIMER button”. ECONO POWERFUL TEMP MODE FAN COMFORT ON/OFF is displayed. blinks. 2.
3PEN291652-2D.book Page 17 Monday, June 8, 2015 2:40 PM To use ON TIMER operation • Check that the clock is correct. If not, set the clock to the present time (page 9.). R 1. Press “ON TIMER button”. is displayed. blinks. 2. Press “TIMER Setting button” until the time setting reaches the point you like. • Every pressing of either button increases or decreases the time setting by 10 minutes. Holding down either button changes the setting rapidly. 3. Press “ON TIMER button” again.
3PEN291652-2D.book Page 18 Monday, June 8, 2015 2:40 PM CARE Care and Cleaning CAUTION Before cleaning, be sure to stop the operation and turn the breaker OFF. Units Indoor unit, Outdoor unit and Remote controller 1. Wipe them with dry soft cloth. Front panel 1. Open the front panel. • Hold the panel at the recesses on the main unit (2 recesses on right and left sides) and lift it until it stops. Recess on main unit 2. Remove the front panel.
3PEN291652-2D.book Page 19 Monday, June 8, 2015 2:40 PM Filters 1. Open the front panel. (page 18.) Recess on main unit • Hold the panel at the recesses on the main unit (2 recesses on right and left sides) and lift it until it stops. 2. Pull out the air filters. • Push the filter tab at the center of each air filter a little upwards, then pull it down. 3. Take off the Titanium Apatite Photocatalytic Air-Purifying Filter. • Hold the recessed parts of the frame and unhook the four claws. 4.
3PEN291652-2D.book Page 20 Monday, June 8, 2015 2:40 PM [ Maintenance ] 1. Remove dust with a vacuum cleaner and wash lightly with water. 2. If it is very dirty, soak it for 10 to 15 minutes in water mixed with a neutral cleaning agent. 3. Do not remove filter from frame when washing with water. 4. After washing, shake off remaining water and dry in the shade. 5. When shaking off remaining water, do not wring the filter. [ Replacement ] 1. Remove the tabs on the filter frame and replace with a new filter.
3PEN291652-2D.book Page 21 Monday, June 8, 2015 2:40 PM TROUBLESHOOTING Troubleshooting These cases are not troubles. The following cases are not air conditioner troubles but have some reasons. You may just continue using it. Case Explanation Operation does not start soon. • This is to protect the air conditioner. You should wait for about 3 minutes. • When ON/OFF button was pressed soon after operation was stopped. • When the mode was reselected.
3PEN291652-2D.book Page 22 Monday, June 8, 2015 2:40 PM Check again. Please check again before calling a repair person. Case The air conditioner does not operate. (OPERATION lamp is off.) Check • • • • Hasn’t a breaker turned OFF or a fuse blown? Isn’t it a power failure? Are batteries set in the remote controller? Is the timer setting correct? Cooling (Heating) effect is poor.
3PEN291652-2D.book Page 23 Monday, June 8, 2015 2:40 PM Call the service shop immediately. WARNING When an abnormality (such as a burning smell) occurs, stop operation and turn the breaker OFF. Continued operation in an abnormal condition may result in troubles, electric shocks or fire. Consult the service shop where you bought the air conditioner. Do not attempt to repair or modify the air conditioner by yourself. Incorrect work may result in electric shocks or fire.
3PEN291652-2D.book Page 24 Monday, June 8, 2015 2:40 PM Fault diagnosis. FAULT DIAGNOSIS BY REMOTE CONTROLLER In the ARC433 series, the temperature display sections on the main unit indicate corresponding codes. 1. When the TIMER CANCEL button is held down for 5 seconds, a “ ” indication flashes on the temperature display section. R ECONO POWERFUL TEMP MODE FAN COMFORT ON OFF ON/OFF SWING CANCEL TIMER CANCEL button It cancels the timer setting. TIMER 2.
3PEN291652-2D.
Copyright 2014 Daikin 3PEN291652-2D.book Page 2 Monday, June 8, 2015 2:40 PM 3P291652-2D 2015.
