Operation Manual

NOTE

■ Notes on the angles of the flap

• The flap swinging range depends on the operation. (See the figure.)

• If the air conditioner is operated in COOL or DRY operation with the flap kept stopped in the downward direction, the flap will automatically

start operating in approximately an hour in order to prevent dew condensation.

■ Note on airflow rate setting

• At smaller airflow rates, the cooling (heating) effect is also smaller.

CAUTION

• Always use a remote controller to adjust the angles of the flap. If you attempt to move the flap and louvers forcibly with hand when they are

swinging, the mechanism may be broken.

• Be careful when adjusting the louvers.

Inside the air outlet, a fan is rotating at a high speed.

■ To adjust the airflow rate setting

Press .

• Each pressing of advances the airflow rate setting in sequence.

• When the airflow is set to “ ”, indoor unit quiet operation will start and the noise from

the unit will become quieter.

• In indoor unit quiet operation, the airflow rate is set to a weak level.

• If the temperature does not reach the desired point in the indoor unit quiet operation,

change the airflow rate setting.

• In DRY mode, the airflow rate setting is not variable.

Auto Indoor unit quiet Low Middle low

MiddleMiddle highHigh

FAN operationHEAT operationCOOL and

DRY operation

Upper limit

Stop operation

wer limit

Upper limit

COMFORT AIRFLOW

Stop operation Stop operation

Lower limit

45°

5°

0°

COMFORT AIRFLOW

15°

45°

50°

0°

45°

5°

0°