Operation Manual

■ Titanium apatite photocatalytic air-purifying filter

1.Take off the titanium apatite

photocatalytic air-purifying

filter.

• Open the front panel and pull out the air filters.

• Hold the recessed parts of the frame and unhook

the 4 claws.

Clean or replace the titanium

apatite photocatalytic air-

purifying filter.

[Maintenance]

2-1 Vacuum dusts, and soak in cold or

lukewarm water (avoid using warm

or hot water) for about 10 to

15 minutes if dirt is heavy.

• Do not remove the filter from frame when washing

with water.

2-2 After washing, shake off remaining

water and dry in the shade.

• Since the material is made out of polyester, do not

wring out the filter when removing water from it.

[Replacement]

Remove the filter from the filter

frame and attach a new one.

• Do not throw away the filter frame. Reuse the filter

frame when replacing the titanium apatite

photocatalytic air-purifying filter.

• Dispose of the old filter as non-flammable waste.

3.Set the filters as they were

and close the front panel.

• Press the front panel at both sides and the center.

NOTE

• Operation with dirty filters:

– cannot deodorize the air,

– cannot clean the air,

– results in poor heating or cooling,

– may cause odour.

• Dispose of old filters as non-flammable waste.

• To order titanium apatite photocatalytic air-purifying filter contact

the service shop where you bought the air conditioner.

Claw

Item

Titanium apatite photocatalytic air-purifying

filter (without frame) 1 set

Part No. KAF970A46