Installation Manual
English 3
CAUTION
Do not install the remote controller in the following locations:
(a) Where a mineral oil mist or oil spray or vapor is produced, for example, in a kitchen.
Plastic parts may deteriorate.
(b) Where corrosive gas, such as sulfurous acid gas, is produced.
(c) Near machinery emitting electromagnetic waves.
Electromagnetic waves may disturb the operation of the control system and cause the unit to malfunction.
(d) Where ammable gas may leak, where there is carbon ber or ignitable dust suspension in the
air, or where volatile ammables such as thinner or gasoline are handled.
Operating the unit in such conditions can cause a re.
(e) High temperature areas or areas with direct ames.
Overheating and/or re can occur.
(f) Moist areas where there is exposure to water. If water enters the inside of the remote controller,
it may cause electric shock and electrical components may fail.
NOTE
Install the control wires for the indoor unit and the remote controller at least 3.5 feet (1 meter) away
from televisions or radios to prevent image interference or noise. Depending on the radio waves, a
distance of 3.5 feet (1 meter) may not be sufcient to eliminate the noise.
When the remote controller’s temperature sensor is used, select the installation location as per the following:
• A place where average temperature in the room can be detected.
• A place where it is not exposed to direct sunlight.
• A place where it is far away from any heat source.
• A place where it is not affected directly by outside air.
Accessories
The following accessories are included.
Drywall screw Drywall anchor Operation Handbook Installation Handbook
(3 pcs.) (3 pcs.) (3 pcs.) (1 pc.)
Mounting plate
(Metal)
Mounting plate
(Plastic)
Screw for mounting plate
(M3.5×10)
Screw for mounting plate
(M4×40)
(1 pc.) (1 pc.) (3 pcs.) (2 pcs.)
01_EN_EM19A026_IM.indd 3 2020/09/08 14:20:59