INSTALLATION MANUAL Wireless remote controller kit BRC7E530W8 BRC7E531W8
1 1 2 1x 1x 3 1x 4 2x 5 2x 6 2x 7 1x 8 1x 9 1x 1 1 1 2 2 2 10 2x 3 3 3 1 2 2 3 3 ON 4 OFF TEMP TIME 1 3 1 A SETTING ON UP FAN A B DOWN 1 C TIMER 4 TIMER D MODE 2 3 5 /TEST 1,6 4 6 7 1 6 7 9 B 1A X C A X2 1 A X1 A X2 8 9 2 1 5 8 5 SWING /TEST A DOWN C SWING 5 3 4 UP RESERVE CANCEL MODE 2 SETTING FAN 2 RESERVE CANCEL B OFF TEMP TIME
BRC7E530W8 BRC7E531W8 CONTENTS Installation manual Wireless remote controller kit Page Meaning of caution symbols Safety considerations .....................................................1 Before installation ...........................................................1 Accessories .................................................................. 1 Note to the installer ......................................................
REMOTE CONTROLLER INSTALLATION Determination of address and MAIN/SUB remote controller Installing wireless remote controller ■ If setting multiple wireless remote controllers to operate in one room, perform address setting for the receiver and the wireless remote controller. ■ If setting multiple wired remote controllers in one room, change the MAIN/SUB switch of the receiver. ■ Do not throw the remote controller or impose large shocks.
Setting the address of wireless remote controller Stick the unit number label (See figure 3) Stick the unit number label on the air outlet of the decoration panel and on the back of the wireless remote controller. A B C Mode Address (is factory set to “1”) Multiple setting Setting from the remote controller 1 Hold down the button and the button for at least 4 seconds to get the Field Set mode. (Indicated in the display area in the figure.) 2 Press the button and select a multiple setting (a/b).
Refer to figure 9. Connect the harness from the transmitter board to the connector X24 on the indoor unit PC board. A B C Be sure to pass only the harness connecting to the indoor unit PC board under the tab. Be sure to wire the harness as shown to avoid the harness to be caught by the control box and the control box lid. Position of the connector in the case of the VRV system. (See figure 4) A B C D MODE NO. FIELD SET MODE FIRST CODE NO. SECOND CODE NO.
TEST OPERATION NOTES ■ Perform the test operation according to the instructions in the installation manual delivered with the indoor unit. ■ After refrigerant piping, drain piping, and electric wiring, operate as follows to protect the unit: 1 Open the gas side stop valve. 2 Open the liquid side stop valve. 3 Electrify for 6 hours. 4 Set to cooling with the remote controller and push the button to start operation. 5 Push the button twice and operate in TEST OPERATION mode for 3 minutes.
4PW23710-1A Copyright © Daikin