Operation Manual
Table Of Contents
- Feature
- Contents
- Safety Considerations
- Names of Parts
- Preparation before Operation
- AUTO · DRY · COOL · HEAT ·FAN Operation
- Adjusting the Airflow Rate
- POWERFUL Operation
- OUTDOOR UNIT QUIETOperation
- ECONO Operation
- OFF TIMER Operation
- ON TIMER Operation
- Note for Multi System
- Care and Cleaning
- Troubleshooting
- Quick Reference
18
English
ON TIMER Operation
To use ON TIMER operation
• Check that the clock is correct.
If not, set the clock to the present time.
Page 10
1. Press .
“ ” is displayed on the LCD.
“
” blinks.
• “ ” is no longer displayed on the LCD.
2. Press until the time setting reaches the
point you like.
• Each pressing of either button increases or decreases the time setting by 10minutes.
Holding down either button changes the setting rapidly.
3. Press again.
• “ ” and setting time are displayed on the LCD.
• The TIMER lamp lights yellow.
Display
To cancel ON TIMER operation
Press .
• “ ” and setting time are no longer displayed on the LCD.
• “
” and day of the week are displayed on the LCD.
• The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
• A sample setting for combining the 2timers is shown below.
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00
Combined
NOTE
In the following cases, set the timer again.
• After a breaker has turned off.
• After a power failure.
• After replacing batteries in the remote controller.
01_EN_3P297290-3C.indd 18 11/17/2015 10:27:20