Service Manual
FTXS Series SiUS091133
73 Operation Manual
NOTE
7.
Press .
8.
Press to select the desired temperature.
6.
Press to select the desired time.
9.
Press .
10.
Press to complete the setting.
• The time can be set between 0:00 and 23:50 in 10 minute intervals.
• To return to the ON/OFF TIMER mode setting, press .
• Go to
STEP
9
when setting the OFF TIMER.
• The time will be set.
• “ ” and the temperature blink.
• The temperature can be set between 50˚F (10˚C) and 90˚F (32˚C).
Cooling: The unit operates at 64˚F (18˚C) even if it is set at 50 (10) to 63˚F (17˚C).
Heating: The unit operates at 86˚F (30˚C) even if it is set at 87 (31) to 90˚F (32˚C).
• To return to the time setting, press .
• The set temperature is only displayed when the mode setting is on.
• The temperature will be set and go to the next reservation setting.
• To continue further settings, repeat the procedure from
STEP
4
.
• Be sure to direct the remote controller toward the indoor unit and check for a receiving
tone and flashing the OPERATION lamp.
• “ ” is displayed on the LCD and WEEKLY TIMER operation is activated.
• The TIMER lamp lights yellow.
• A reservation made once can be easily copied and the same settings used for another
day of the week. Refer to .
Notes on WEEKLY TIMER operation
• Do not forget to set the clock on the remote controller first.
• The day of the week, ON/OFF TIMER mode, time and set temperature (only for ON TIMER mode) can be set with WEEKLY TIMER.
Other settings for ON TIMER are based on the settings just before the operation.
• Both WEEKLY TIMER and ON/OFF TIMER operation cannot be used at the same time. The ON/OFF TIMER operation has priority if it is set
while WEEKLY TIMER is still active. The WEEKLY TIMER will go into standby state, and
“ ” will be no longer displayed on the LCD.
When ON/OFF TIMER is up, the WEEKLY TIMER will automatically become active.
• Only the time and set temperature with the WEEKLY TIMER are sent with the . Set the WEEKLY TIMER only after setting the operation
mode, the airflow rate and the airflow direction ahead of time.
• Shutting the breaker off, power failure, and other similar events will render operation of the indoor unit’s internal clock inaccurate. Reset the
clock.
• The can be used only for the time and temperature settings. It cannot be used to go back to the reservation number.
Display
Page 25