Service Manual

SiUS091133 FDXS Series
Operation Manual 86
3.8 ON TIMER Operation
ON TIMER Operation
 To use ON TIMER operation
• Check that the clock is correct.
If not, set the clock to the present time.
1. Press .
“ ” is displayed on the LCD.
“ ” blinks.
• “ ” is no longer displayed on the LCD.
2. Press until the time setting reaches the
point you like.
• Each pressing of either button increases or decreases the time setting by 10 minutes.
Holding down either button changes the setting rapidly.
3. Press again.
• “ ” and setting time are displayed on the LCD.
• The TIMER lamp lights yellow.
Display
 To cancel ON TIMER operation

To combine ON TIMER and OFF TIMER
Press .
• “ ” and setting time are no longer displayed on the LCD.
• “ ” and day of the week are displayed on the LCD.
• The TIMER lamp goes off.
• A sample setting for combining the 2 timers is shown below.
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
Combined
ON TIMER at 14:00
NOTE
• After a breaker has turned off.
• After a power failure.
• After replacing batteries in the remote controller.
 In the following cases, set the timer again.
3P297290-3