Installation manual

English
■English 4
Indoor Unit Installation Drawings
Screws
(M4 × 16L)
Service lid
Caulk pipe
hole gap
with putty.
Wrap the insulation pipe
with the finishing tape
from bottom to top.
Cut thermal insulation
pipe to an appropriate
length and wrap it with
tape, making sure that no
gap is left in the insulation
pipe’s cut line.
Bottom frame
Front grille
How to attach the indoor unit
Hook the claws of the bottom frame
to the mounting plate.
If the claws are difficult to hook,
remove the front grille.
How to remove the indoor unit
Push up the marked area (at the
lower part of the front grille) to
release the claws. If it is difficult to
release, remove the front grille.
Opening service lid
Service lid is opening/closing type.
Opening method
1) Remove the service lid screw.
2) Pull out the service lid diagonally
down in the direction of the arrow.
3) Pull down.
The mounting plate
should be installed on a
wall which can support the
weight of the indoor unit.
30mm or more from ceiling
Front panel
50mm or more from walls
(on both sides)
Air filters
A Mounting plate
A Mounting
plate
Mounting plate
fixing screw
(field supply: M4 × 25L)
C Wireless remote controller
Fixing screw for remote
controller holder
(field supply: M3 × 20L)
D Remote controller
holder
Air filter
Titanium apatite
photocatalytic
air-purifying filter
Filter frame
Tab
Titanium apatite photocatalytic
air-purifying filter (2 pcs)
Before screwing the
remote controller holder
to the wall, make sure
that control signals are
properly received by
indoor unit.
Clip
Mark (rear side)
B
01_EN_3P297034-1.indd 4 10/12/2011 11:37:01 AM