Operation Manual
11
AUTO · DRY · COOL · HEAT ·
FAN Operation
The air conditioner operates with the operation mode of your choice.
From the next time on, the air conditioner will operate with the same operation mode.
■
To start operation
1. Press and select an operation mode.
• Each pressing of the button advances the mode setting in sequence.
AUTO DRY COOL HEAT FAN
2. Press .
• “ ” is displayed on the LCD.
• The OPERATION lamp lights green.
Display
■
To stop operation
Press again.
• “ ” disappears from the LCD.
• The OPERATION lamp goes off.
NOTE
MODE Notes on each operation mode
HEAT
• Since this air conditioner heats the room by taking heat from outdoor air to indoors, the heating capacity becomes smaller in
lower outdoor temperatures. If the heating effect is insufcient, it is recommended to use another heating appliance in
combination with the air conditioner.
• The heat pump system heats the room by circulating hot air around all parts of the room. After the start of HEAT operation,
it takes some time before the room gets warmer.
• In HEAT operation, frost may occur on the outdoor unit and lower the heating capacity. In that case, the system switches
into defrosting operation to take away the frost.
• During defrosting operation, hot air does not ow out of indoor unit.
COOL
• This air conditioner cools the room by releasing the heat in the room outside.
Therefore, the cooling performance of the air conditioner may be degraded if the outdoor temperature is high
DRY
• The computer chip works to rid the room of humidity while maintaining the temperature as much as possible. It automatically
controls temperature and airow rate, so manual adjustment of these functions is unavailable.
AUTO
• In AUTO operation, the system selects an appropriate operation mode (COOL or HEAT) based on the room and outside
temperatures and starts the operation.
• The system automatically reselects setting at a regular interval to bring the room temperature to user-setting level.
FAN • This mode is valid for fan only.