MXS Service Manual

Table Of Contents

SiUS121736EA Indoor Unit

Printed Circuit Board Connector Wiring Diagram 34

1.5 FVXS09/12/15/18NVJU

Control PCB

(PCB2)

Caution Replace the PCB if you accidentally cut a wrong jumper.

Jumpers are necessary for electronic circuit. Improper operation may occur if you cut any of them.

Note: The symbols in the parenthesis are the names on the appropriate wiring diagram.

1) S1 Connector for DC fan motor

2) S21 Connector for centralized control (HA)

3) S26 Connector for service PCB (PCB3)

4) S32 Indoor heat exchanger thermistor

5) S41 Connector for lower air outlet motor

6) S42 Connector for swing motor

7) S46 Connector for display/signal receiver PCB (PCB4)

8) S48 Connector for sensor PCB (PCB1)

9) H1, H2, H3 Connector for terminal strip

10) E1 Terminal for ground wire

11) JA Address setting jumper

∗ Refer to page 234 for details.

12) JB Fan speed setting when compressor stops for thermostat OFF

∗ Refer to page 236 for details.

13) JC Power failure recovery function

∗ Refer to page 236 for details.

14) FU1 (F1U),

FU2 (F2U)

Fuse (3.15 A, 250 V)

15) LED A LED for service monitor (green)

16) V1, V2 Varistor

FU1 H1 S1 LEDA S21 S41 S42 S26

S46

S48

FU2

S32

2P383711-1